DIGITUS DA-12003 Ear Office Headset with Noise Reduction, USB Installation Guide
- June 7, 2024
- DIGITUS
Table of Contents
DIGITUS DA-12003 Ear Office Headset with Noise Reduction, USB
Specifications
| DA-12003 | DA-12004 | |
|---|---|---|
| Connection type | USB 2.0 (USB A) | |
| Connection cable length | 195 cm | |
| Features | Microphone noise reduction (one |
direction)
Control module| Volume control & mute for
microphone and speaker
Earpiece diameter| 30 mm| 40 mm
Earpiece cushions| Foam| Synthetic leather
Headphone sensitivity| 115 dB ± 3dB
Headphone impedance| 32 Ohm
Headphone frequency| 20 – 20,000 Hz
Max. power| 84 mW
Microphone sensitivity| -42 dB| -52 dB
Microphone impedance| ≤ 2.2 kOhm
Microphone frequency| 50 – 15,000 Hz
Operating systems| Windows 10/8/7/XP, macOS 10.4 or
higher
Packaging Content
- 1 x On-Ear Office Headset with Noise Reduction, USB
- 1 x QIG
Installation
To use the USB headset, simply connect it to an available USB port on your computer. Installation on both Windows and Mac operating systems will be automatic and completed shortly after connecting the headset. Once the installation is complete, you can verify that the headset is ready to use by following these steps:
Windows
Go to Control Panel > Sound and check that the USB PnP Sound Device is set as
the default device in both the Playback and Recording tabs.
macOS
Go to System Preferences > Sound and check that USB PnP Sound Device is set as
the default device in both the Input and Output tabs.
The USB headset can control the output volume of your computer using the
volume up and down buttons and can completely mute audio output via the
headphone mute button. It is possible to monitor the level that the computer
is set to by hovering the mouse over the speaker icon in the system tray in
Windows, whilst macOS will show the volume adjustment on screen with each
button press. It is also possible to mute just the microphone by using the
microphone mute button. A red LED will illuminate on the controller to signify
that the = microphone is muted.
Under normal operation the green LED will flash, if it is permanently lit please adjust the microphone level: Windows > Control Panel > Sound > Recording > USB PnP Sound Device > Properties > Levels macOS > System Preferences > Sound > Input > USB PnP Sound Device > Input Volume
Controls
Hereby Assmann Electronic GmbH declares that the Declaration of Conformity is part of the shipping content. If the Declaration of Conformity is missing, you can request it by post under the below mentioned manufacturer address.
www.assmann.com
Assmann Electronic GmbH
Auf dem Schüffel 3
58513 Lüdenscheid
Germany
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>