Panorama Antennas DMM-6-60 Ultra Wideband 4G/5G MiMo Antenna Instruction Manual
- June 7, 2024
- Panorama Antennas
Table of Contents
Panorama Antennas DMM-6-60 Ultra Wideband 4G/5G MiMo Antenna Instruction
Manual
Introduction
The DMM antenna is a 2×2 MIMO (multiple input multiple output) / diversity capable accessory antenna designed to improve reception for 2G / 3G/ 4G and some 5G modem devices.
Positioning the Antenna
The DMM is designed to operate with MIMO enabled modems which are able to take advantage of the scattered signal paths which exist in everyday indoor environments. For this reason the user can be very flexible about where they position the antenna. The antenna is omni-directional and does not need to be facing any particular direction to operate. The antenna should not be positioned too close to metal objects as this may affect performance.
Desk mounting
The DMM can be easily desk mounted using the integrated fold out feet as
shown at fig. 1. Simply fold out both feet and position the antenna as
desired. The feet can then be re-stowed for transport.
Adhesive pad mounting
The DMM can mounted to any non-conductive surface using the supplied
adhesive pad see fig. 2. Ensure the area where you wish to mount the antenna
is flat and level and free of grease and dirt. The adhesive pad should be
placed centrally and can be fitted on either side of the antenna by removing
the carrier film and pressing firmly. Once mounted to the antenna follow the
same process to mount to the mounting panel. For optimal pad adhesion the
ambient temperature should be 10°C – 30°C (50°F -86°F).
Suction cup mounting
The DMM can be suction mounted to a window or other smooth surface
utilising the supplied suction cup. Simply screw the suction cup to the top
most mounting position as shown in fig. 3. Proceed to mount the antenna by
pressing it firmly onto the desired surface until a firm grip is acheived. To
dismount the antenna hold the antenna firmly and unscrew the antenna from the
suction cup. The suction cup can then be removed from the mounting surface
with ease.
Screw mounting
The antenna can be mounted to appropriate surfaces using the supplied self-
tapping screws and wall plugs as per fig. 4. Check for obstructions under the
mounting panel and then drill appropriate holes using the antenna as a
template if required. Take care not to over-tighten screws when mounting as
this may break the mounting tabs- using the supplied spacers will help avoid
over tightening.
Routing the cables
Route the dual coaxial cables from the antenna to the modem. The cables should not remain bunched or tightly wound as this may affect performance.
-
Fold out desk stand feet
-
Installing using adhesive pad
-
Installing using suction cups
-
Installing using screws
Warranty
This accessory is guaranteed to be free from defects in the material and workmanship for 12 months from the date of purchase. If your accessory is found to be faulty please return the product to Panorama Antennas with proof of purchase. This warranty excludes normal wear and tear. This does not affect your statutory rights.
THIS WARRANTY DOES NOT APPLY IN AUSTRALIA.
Important safety notes
RF Safety Note – Ensure that the antenna is mounted in such a way that no person is likely to be within a distance of 30cms (12”) from the antenna during use. Ensure that the antenna is used only as supplied the co-axial cables should not be cut shorter or otherwise modified.
General Safety Note – Make sure that the product is mounted so that it cannot fall and cause injury. Do not chew the product or put it in your mouth. Do not leave children unsupervised with the product or packaging.
Waste electrical products should not be disposed of with household waste. All
electronic products with the WEEE logo must be collected and sent to approved
operators for safe disposal or recycling. Please recycle where facilities
exist. Many electrical/electronic equipment retailers facilitate “Distributor
Take-Back scheme”for household WEEE. Check with your Local Authority or
electronic retailers for designated collection facilities where WEEE can be
disposed of for free.
RoHS 2 compliance is declared per Directive 2011/65/EU and its subsequent amendments with exemption 6.c applied. This product contains lead as an alloying element in a copper alloy containing up to 4% lead by weight.
REACH (Registration, Evaluation, Authorisation and Restriction of Chemicals, EC 1907/2006) This product contains Lead (CAS No. 7439-92-1) which is classified as an SVHC (Substance of Very High Concern) as being toxic to reproduction under Article 57c. of REACH.
Do not chew parts or put them in mouth, keep away from unsupervised children.
Dispose of parts as WEEE waste do not send to landfill.
Contact Information
-
Panorama Antennas Ltd
Head office united kingdom
61 Frogmore, Wandsworth, London, SW18 1HF
sales@panorama-antennas.com
+44 (0)20 8877 4444 -
Panorama Antennas Inc
USA
1551 Heritage Parkway, Suite 101, Mansfield, TX, 76063
sales.nam@panorama-antennas.com
+1 817-539-1888 -
Panorama Antennas Pty Ltd
Australia
Unit 1, 5 Jaggs Way, Kardinya, WA 6163
+61 406 812 364
sales.apac@panorama-antennas.com -
Panorama Antennas SAS
France
fr.sales@panorama-antennas.com
+33 554 070 436
16 Allée des Acacias, 33700 Mérignac -
Panorama Antennas Pte Ltd
Singapore
sales.sea@panorama-antennas.com
+65 9155 4194
Space@ Tampines, 18 Tampines Industrial Crescent, 528605 -
Panorama Antennas Ltd
Germany
de.sales@panorama-antennas.com
+49 2303 902 88 00
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>