allen roth 24-in Vanity with Top Installation Guide

welcoming

ITEM #3037120
24-IN VANITY
WITH TOP
MODEL #2026VA-24-201-901

ALLEN + ROTH
and logo design are trademarks or registered
trademarks of LF, LLC. All rights reserved.

ATTACH YOUR RECEIPT HERE
Serial Number_ Purchase Date___
Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 1-866-439-9800, 8  a.m. – 8 p.m., EST, Monday – Sunday. You could also contact us at partsplus@lowes.com or visit www.lowespartsplus.com.

PACKAGE CONTENTS

E

| Left Door (preassembled to vanity (A))|

1

F

| Right Door (preassembled to vanity (A))|

1

G| Floor Plumbing Cutout Lid| 1
H| Shelf| 1

HARDWARE CONTENTS (NOT SHOWN ACTUAL SIZE)

SAFETY INSTRUCTIONS

Please read and understand this entire manual before attempting to assemble, operate or install the product.
WARNING

• There are several assembly steps, including unpacking, that require two adults.

CAUTION

• DO NOT try to pry off the top from vanity, as damage to top or vanity may occur.
• Follow these instructions closely, take your time, and use care while assembling this vanity.

KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.

PREPARATION

Before beginning the assembly of the product, make sure all parts are present. Compare parts with package contents list and hardware contents list. If any part is missing or damaged, do not attempt to assemble the product.
Estimated Installation Time: 45 minutes (24 hours for silicone caulk to dry).
Tools Required for Installation (not included): Phillips screwdriver, utility knife or scissors, silicone caulk, power drill with drill bit Helpful Tools (not included): Measuring tape, level

INSTALLATION INSTRUCTIONS

Note: Clean area where the vanity (A) will be permanently located prior to beginning installation, ensuring the vanity (A) will not interfere with any water supply and drain lines once mounted.

1. With two people, carefully place vanity (A) with Top (B) against the wall in its final location. While holding the vanity base firmly against the wall, use the pre-assembled levelers on the bottom of each leg of the vanity (A) to level the item. Twisting  the levelers counterclockwise will raise the height of the vanity (A) and twisting them clockwise will lower the vanity.
   Once the vanity is in place, against the wall, and level from front to back and side to side, drill a hole through the vanity mounting area and into the wall studs (as illustrated in diagram 1). Using appropriate mounting hardware (not included),  secure the vanity (A) to a wall stud. If possible, secure the vanity (A) to two wall studs for increased stability.
   WARNING Vanity (A) MUST be secured to the wall.

2. Apply silicone caulk (not included) to unpolished side and bottom of backsplash (C). Position backsplash (C) on top (B) and against the wall. Clean any excess caulk before allowing it to dry.

3. The back of the vanity is open for accessibility for drain(s) and water line(s) hookup. If your plumbing comes out of the back wall, insert the floor plumbing cutout lid (G), as shown in Illustration 3. This will close the hole and increase your storage space. If your plumbing comes out of the floor, this hole provides accessibility for drain and water line hookup.
   

4. From the front of the assembly, insert shelf pins at the desired height, ensuring they are level. Place shelf (H) on top of shelf pins.
   

5. 5. If you need to adjust the doors, do so in the following manner.
   To adjust the door up or down, loosen screws (a) on both hinges, adjust the door, and retighten the screws.
   To adjust the door left or right, turn screws (b) on both hinges, in and out.
   To adjust the door in or out, loosen screws (c) on both hinges, adjust the door, and retighten screws.
   Assembly is now complete. Install desired faucet and drain assemblies (neither included) per the manufacturers’ instructions to complete the installation.
   

CARE AND MAINTENANCE

• Dust the vanity regularly with a soft, non-lint producing cloth or household dusting product.
• You can clean the vanity with a gentle, non-abrasive household cleaner.
• Make sure to dry the wood immediately with a soft cloth or towel.
• The stone top can be cleaned using standard marble cleaning agents available at your local supplier.
• Tips for using a touch-up pen (AA): For scratches, stroke in direction of the scratch. Rub off excess colorant promptly with a soft cloth.

IMPORTANT

• Shade variations and patterns are an inherent characteristic of stone (e.g. granite, marble, engineered stone). Stone tops will vary from product to product. Use caution placing items such as soap or any fragranced material on the stone surface. Use a  soap dish, coaster, or similar item to protect the surface if placing any soap or fragranced products on the stone.
  If soap or fragranced products come in contact with the stone top, rinse the surface with water and dry using a soft non-abrasive cloth.

• WARNING: Must use cleaning agents safe for stone. Check your cleaning agents’ use restrictions before using on any stone. Damage to the stone may result. Vanity manufacturers are not responsible for damage caused by improper cleaning agents or soaps used. Warranty will not cover damage caused by the use of improper soaps or cleaning agents.

• DO NOT use products to clean the stone top that contains acetone, lemon, vinegar, or other acids as these may cause damage to the stone surface.

• Periodically reseal the stone top using an appropriate stone sealer available from your local home store. Follow the manufacturer’s directions on how to apply.

WARRANTY

The manufacturer warrants this item against defects in materials and workmanship for a period of one (1) year from the date of original retail purchase. This warranty applies only to the original purchaser. This warranty does not apply to any damage on the product by accident, misuse, or modified, improper installation, or by affixing accessories not produced by the manufacturer. The manufacturer is not accountable whatsoever for product installation during the warranty period. There is no further expressed warranty. The manufacturer shall not be legally responsible for incidental, consequential, or special damages arising at or in connection with product use or performance except as may otherwise be accorded by law. The manufacturer disclaims any and all implied warranties.

REPLACEMENT PARTS LIST

For replacement parts, call our customer service department at 1-866-439-9800, 8 a.m. – 8 p.m., EST, Monday – Sunday. You could also contact us at partsplus@lowes.com or visit www.lowespartsplus.com.

Printed in Vietnam
ALLEN + ROTH
and logo design are trademarks or registered
trademarks of LF, LLC. All rights reserved.

Documents / Resources

| allen roth 24-in Vanity with Top [pdf] Installation Guide
allen roth, 24-in Vanity with Top, 2026VA-24-201-901
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>