NetComm CloudMesh Satellite NS-01 User Guide
- June 7, 2024
- NetComm
Table of Contents
NS-01
QUICK START GUIDE
WHAT’S IN THE BOX
- 1 x NS-01 CloudMesh Satellite
- 1 x Ethernet Cable
- 1 x USB-C Power Adapter
- 1 x Quick Start Guide
WHAT YOU WILL NEED
CloudMesh-enabled gateway connected to internet
A
PowerPoint near to where you want to place the CloudMesh Satellite
SAFETY INFORMATION
PLEASE READ BEFORE USE
LOCATION
This device is designed for indoor use only Place the device in a central
location to the area you want to cover for the best WiFi performance.
AIRFLOW
Do not restrict airflow around the device. The device is air-cooled and may
overheat where airflow has been restricted. Always allow a minimum of 5cm
clearance around all sides and the top of the device. Do not cover, do not put
in an enclosed space, do not put under or behind large items of furniture.
Your device may become warm during normal use.
ENVIRONMENT
Do not place this device in direct sunlight or any hot areas. The safe
operating temperature range of this device is between 0° and 40°C. Do not
allow this device to come in contact with any liquid or moisture. Do not place
this device in any wet or humid areas such as kitchens, bathrooms, or
laundries.
POWER SUPPLY
Use only the power supply unit that came with the device. You should
immediately stop using the power supply unit if the cable or power supply unit
is damaged.
SERVICE
There are no user-serviceable components in the device. Do not attempt to
disassemble, repair, or modify the device.
SMALL CHILDREN
Do not leave your device and its accessories within the reach of small
children or allow them to play with it. Your device contains small parts with
sharp edges that may cause an injury or which could become detached and create
a choking hazard.
RF
EXPOSURE
The device contains a transmitter and a receiver. When it is on, it receives
and transmits RF energy. The device conforms with the radio frequency (RF)
exposure limits adopted by the Australian Communications and Media Authority
Radiocommunications (Electromagnetic Radiation – Human Exposure) Standard 2014
when used at a distance of not less than 20 cm from the body.
PRODUCT HANDLING
- Always treat your device and its accessories with care and keep it in a clean and dust-free place.
- Do not expose your device or its accessories to open flames.
- Do not drop, throw or try to bend your device or its accessories.
- Do not use harsh chemicals, cleaning solvents, or aerosols to clean the device or its accessories.
- Do not paint your device or its accessories.
- Please check local regulations for the disposal of electronic products.
- Arrange power and Ethernet cables in a manner such that they are not likely to be stepped on or have items placed on them.
Your CloudMesh Satellite works best when it is placed in a central location to the area you want to cover. Ideally, it should be located no more than two rooms away from the CloudMesh Gateway.
Before you begin, ensure your CloudMesh Gateway is connected to the Internet.
-
Connect the Power adapter to the CloudMesh Satellite
Wait
five minutes for the CloudMesh Satellite to initialize and then check the
light status. A solid white or blue light means the satellite has been paired
with the Gateway and is ready to use. -
A solid red light means that the Satellite needs to be moved closer to the Gateway. If after five minutes, the light is still flashing blue, follow the instructions on page 18.
| | 1 Red flashing| Powering up
---|---|---|---
| | 2 Purple solid| Powering up
| | 3 Blue flashing| Ready for pairing/not connected to mesh network
When connected to the CloudMesh Gateway, the light shows the signal strength as follows:
| | White solid| Good signal
---|---|---|---
| | Blue solid| Medium signal
| | Red solid| Poor signal
If the CloudMesh Satellite light is still flashing blue after five minutes, you will need to pair it with the CloudMesh Gateway.
-
Place the CloudMesh Satellite next to your CloudMesh Gateway. Wait for both devices to power on. Ensure that the CloudMesh Gateway is connected to the Internet.
Press
and release the WPS button on the Satellite, then press and release the 5G WPS
button on the Gateway within two minutes. -
The pairing process can take up to five minutes. When the Satellite has paired, refer to the light status tables on page 17.
DOWNLOAD THE CLOUDMESH APP
Finding the best place for your CloudMesh Satellite is easy using the
CloudMesh App.
- Satellite placement assistance
- WiFi Analytics
- WiFi client monitoring
Get it on the App Store or Google Play.
| NetComm
---|---
| casa systems
| ANZ HEAD OFFICE SYDNEY
Casa Systems Inc.
18-20 Orion Road, Lane Cove NSW 2066, Sydney
Australia | +61 2 9424 2070
www.netcomm.com
---|---
|
CORPORATE HEADQUARTERS ANDOVER
Casa Systems Inc.
100 Old River Road,
Andover, MA 01810
USA | +1 978 688 6706
www.casa-systems.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>