NetComm NS-01 CloudMesh Business Wi-Fi Booster User Guide

: June 4, 2024
: NetComm

Table of Contents

NS-01 CloudMesh Business Wi-Fi Booster
What’s included in the box?
Lights
Important information:
Support details
Documents / Resources

Business
Wi-Fi Booster
User Guide

NS-01 CloudMesh Business Wi-Fi Booster

To enhance your Wi-Fi performance, install the Business Wi-Fi Booster in your premises to improve a low Wi-Fi signal and heighten your experience. It is a simple process and can be done in minutes, simply following the step-by-step guide.

What’s included in the box?

| 1 x Business Wi-Fi Booster
---|---
| 1 x Ethernet Cable
| 1 x USB-C Power Adapter
| 1 x Business Wi-Fi Booster Quick Start Guide

Plug in the Commander Business Modem and ensure it is connected to the Internet (details for the installation were sent to you via email or simply follow the instructions available on our support page commander.com.au/support/internet-bundles under: How do I set up my modem?)
Tip: Ensure your Commander Business Modem has been set up correctly, and the correct lights are on before you pair the Business Wi-Fi Booster.
Place the Business Wi-Fi Booster next to your Commander Business Modem, connect the Business Wi-Fi Booster to power and switch it on.
Plug the yellow RJ45 ethernet cable (supplied with the Business Wi-Fi Booster) into a free yellow ethernet port on the back of the Commander Business Modem, and the other end into the Business Wi-Fi Booster.
Allow up to 5 minutes for the Business Wi-Fi Booster to download information from Commander Business Modem, the LED will turn solid white or blue, depending on the signal strength.
Unplug the ethernet cable from between the two devices and position the Business Wi-Fi Booster in a satisfactory location on your premises.
Power on the Business Wi-Fi Booster. Wait approximately 10 minutes as the Business Wi-Fi Booster attempts to pair with the Commander Business Modem, and the LED will flash blue.
Tip: If you have a poor signal (red solid light), move the Business Wi-Fi Booster closer to the Commander Business Modem.

Lights

Your Business Wi-Fi Booster light follows this sequence when first turned on:

| Red flashing| Powering up
---|---|---
| Purple solid| Powering up
| Blue flashing| Ready for pairing/not connected to mesh network

When connected, the light shows the signal strength as follows:
Positioning the Business Wi-Fi Booster correctly is key to ensuring optimal Wi-Fi coverage. The LED lights on the front of your Business Wi-Fi Booster will indicate the status and strength of its connection to your Commander Business Modem.

| White solid| Good signal
---|---|---
| Blue solid| Medium signal
| Red solid| Poor signal^

^We recommend you relocate the Business Wi-Fi Booster, it works best when it is placed in a central location to the area you want to be covered. Ideally, it should be located no more than two rooms away from the Commander Business Modem.

Important information:

This Business Wi-Fi Booster will only work with a Commander Business Modem (NL1901)

Support details

We are dedicated to excellence in servicing our customers and have lots of ways for you to keep in touch:

Online:	commander.com.au/contact-us
Email:	customerservice@commander.com
Phone:	132 777 (Check website for opening hours).

Business Wi-Fi Booster

Documents / Resources

| NetComm NS-01 CloudMesh Business Wi-Fi Booster [pdf] User Guide
NS-01, CloudMesh Business Wi-Fi Booster, NS-01 CloudMesh Business Wi-Fi Booster
---|---