ALLDATA 206-05B Parking Brake Actuator Motor Instruction Manual

ALLDATA 206-05B Parking Brake Actuator Motor Instruction Manual

Removal

NOTE: Removal steps in this procedure may contain installation details.

RH or LH parking brake actuator motor

1. With the vehicle in NEUTRAL, position it on a hoist.
   Refer to: Jacking and Lifting – Overview (100-02 Jacking and Lifting, Description and Operation).

2. NOTE: RH side shown, LH similar.
   Disconnect the parking brake actuator motor electrical connector.
   
   RH parking brake actuator motor

3. NOTE: If there is evidence of brake fluid found in or around the parking brake actuator motor a new brake caliper and actuator motor assembly must be installed.
   Remove the 2 bolts and the parking brake actuator motor. Discard the bolts. Torque: 71 lb.in (8 Nm)
   
   LH parking brake actuator motor

4. NOTICE: Due to minor differences in LH brake hoses, on some vehicles it may be necessary to disconnect the brake hose from the brake caliper to provide enough clearance to remove the actuator motor. Do not pry on or bend the metal portion of the brake hose or damage to the hose may occur.
   NOTE: If there is evidence of brake fluid found in or around the parking brake actuator motor a new brake caliper and actuator motor assembly must be installed.
   Remove the 2 bolts and the parking brake actuator motor. Discard the bolts. If there is not enough clearance to remove the LH actuator motor proceed to the next step.
   Torque: 71 lb.in (8 Nm)
   

5. NOTE: Make sure that protective caps are removed prior to installation.

6. NOTICE: The blanking caps/plugs must not be removed until the brake tubes are ready to be connected.
   Remove the bolt and disconnect the brake hose. Discard the washers.
   Torque: 26 lb.ft (35 Nm)

7. Remove the parking brake actuator motor.
   
   RH or LH parking brake actuator motor

8. NOTE: RH side shown, LH similar.
   Remove and discard the O-ring.
   

Installation

1. To install, reverse the removal procedure.

2. Install and lubricate the O-ring with the lubricant provided with the service kit.
   

3. NOTE: This step is only necessary if the LH brake flexible hose was disconnected.

Bleed the brake system.
Refer to: Brake System Pressure Bleeding (206-00 Brake System – General Information, General Procedures).

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>