CALIBER RMD 015 User Manual

June 6, 2024
CALIBER

Calibar

CALIBER RMD 015

CALIBER RMD 015

Specification

General:
  • Power supply: 12V DC
  • Max power output: 55Wx4 channels
  • RMS power output: 5Wx4 channels
  • Suitable speaker impedance: 4-8 ohm
  • Fuse: 10A
  • Dimensions(WxHxD):  17 8x50x38mm
Radio:
  • FM Stereo Radio: 87.5-108.0 MHz (Europe)
  • Frequency range : 40dB
  • Signal/noise ratio: <37dBf
  • Radio sensitivity

Note: specifications and design are subject to change without prior notice.

Overview

Overview

  1. CLK/ AMS
    CLK: in radio mode, hold 2 sec. to show clock
    in clock mode: hold to set clock (using Vol+Nol-).
    In clock setting mode, push to switch between hours/ minutes
    AMS: in radio mode, push once to start auto. scan and storage
    in USBISD mode, push to pause and push again to resume again

  2. Vol+
    To increase the volume

  3. In radio mode: – Push to go to the next preset station (after AMS scan only)
    – Hold to scan manually to the next station,
    Note: you can not save this to a preset no.
    In MP3 mode: – Push to go to the next track – Hold to fast forward the current track

  4. Mod
    – Press to turn the unit ON and hold to tun the unit OFF Note: when OFF, the display will keep showing the clock
    – When ON, press repeatedly to switch between modes(Radio I USB I SD I AUX)

  5. Display
    Shows the frequency, clock or playback info

  6. AUX-in
    3.5mm Jack connection for audio input

  7. Micro SD
    Micro SD card slot (up to 32GB)

  8. USB
    Standard USB port (up to 32GB)

  9. Reset
    Use a non-metal pin to set the unit back to factory settings

  10. In radio mode: – Push to go to the previous preset station (after AMS scan only)
    – Hold to scan manually to the prev. station, Note: you can not save this to a preset no.
    In MP3 mode: – Push to go to the previous track – Hold to fast rewind the current track

ISO connector:

ISO Connector

WARNING!
To connect the unit, use ISO connectors only.
If your vehicle isn’t equiped with an ISO connector, please use a ISO loom cable. Do not cut off the ISO connector
Damage caused by faulty wiring: warranty will be void.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals