HUAWEI SuperCharge Car Charger – Max 66W SE User Guide

: June 6, 2024
: Huawei

Table of Contents

Product Image
Instructions
Safety Information
Disposal and Recycling Information
FCC statement
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

HUAWEI SuperCharge Car Charger
(Max 66W SE)
Quick Start Guide

Model: P0006
55032929_01

Product Image

HUAWEI SuperCharge Car Charger- Product Image

Product model	P0006
Rated input voltage	12 V DC to 24 V DC
USB 1 output (orange)	5 V/3 A,10 V/4 A, 11 V/6 A (Max)
USB 2 output (black)	5 V/2 A
Cover material	Aluminum alloy body and heat and fire-resistant PC for the USB

cover
Working temperature| -10°C to +40°C

Instructions

To ensure product safety, the car charger is equipped with an intelligent detection chip and must be connected to a Huawei original cable (able to withstand 6 A or higher current) and a device that supports the 11 V 6 A protocol, to achieve super-fast charging (11 V, 6 A maximum).
The female socket of the cigarette lighter or power port may vary with the vehicle model and may not match the car charger. The recommended inner diameter of the female socket or power port is 20.7 mm to 21.5 mm.
For ITE/AV use only.

Safety Information

Avoid allowing the product to take heavy knocks during use.
Do not disassemble or take apart the product.
Avoid allowing the product to be left in direct sunlight.
Please only use the device within its approved operating range of -10°C to +40°C, and only allow it to be exposed to temperatures within its approved storage range of -40°C to +70°C. Extreme heat or cold may damage the device.
The device is not a toy. Children should only use the device when supervised by an adult.
Avoid submerging or leaving the product in moist environments.
Do not use chemicals, powders, or strong detergents to clean the product.
Connecting the product with unapproved or incompatible data cables is unadvised, as this presents a fire or explosion risk.
Do not place the device directly above or within the reach of vehicle airbags. This is due to the fact that in the event of an airbag deployment, the device could take a strong impact and potentially causes severe injury to people inside the vehicle.
Avoid dusty, damp, or dirty environments. Avoid magnetic fields. Using the device in these environments may result in circuit malfunctions.
For safe and reliable charging, do not use an onboard diagnostics (OBD) port, a cigarette lighter expansion device, or a converted port to supply power to the car charger. Otherwise, power supply faults may occur.
If the cigarette lighter or power port is blocked by a cover, do not forcibly close the cover unless you have checked that the cover will not come into contact with the charger. Forcibly closing the cover may cause the cover to be stuck or damaged.

Disposal and Recycling Information

The crossed-out wheeled bin symbol on your product, battery, literature or packaging reminds you that all electronic products and batteries must be taken to separate waste collection points at the end of their working lives; they must not be disposed of in the normal waste stream with household garbage. It is the responsibility of the user to dispose of the equipment using a designated collection point or service for separate recycling of waste electrical and electronic equipment (WEEE) and batteries according to local laws.
Proper collection and recycling of your equipment help ensure electrical and electronic equipment (EEE) waste is recycled in a manner that conserves valuable materials and protects human health and the environment, improper handling, accidental breakage, damage, and/or improper recycling at the end of its life may be harmful for health and environment. For more information about where and how to drop off your EEE waste, please contact your local authorities, retailer or household waste disposal service or visit the website http://consumer.huawei.com/en/.
Reduction of Hazardous Substances
This device and its electrical accessories are compliant with local applicable rules on the restriction of the use of certain hazardous substances in electrical and electronic equipment, such as EU REACH, RoHS and Batteries (where included) regulations. For declarations of conformity about REACH and RoHS, please visit our website http://consumer.huawei.com/certification.
EU regulatory conformance Statement

Hereby, Huawei declares that this device P0006 is in compliance with the essential requirements and other relevant provisions of the following Directives:
–RoHS Directive 2011/65/EU
–LVD Directive 2014/35/EU
–EMC Directive 2014/30/EU
The following marking is included in the product:
This device may be operated in all member states of the EU.
–Observe national and local regulations where this device is used.
–This device may be restricted for use, depending on the local network.

FCC statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
–Reorient or relocate the receiving antenna.
–Increase the separation between the equipment and receiver.
–Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
–Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Caution: Any changes or modifications to this device not expressly approved by Huawei for compliance could void the user’s authority to operate the equipment.

IC Statement
This device complies with CAN ICES-3(B)/NMB-3(B).
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science, and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:

This device may not cause interference.
This device must accept any interference, including interference that may cause undesired operation of the device.

Legal statement
Copyright © Huawei 2020. All rights reserved.
This document is for reference only. Nothing in this guide constitutes a warranty of any kind, express or implied.
All pictures and illustrations in this guide, including but not limited to the product color, size, and display content, are for your reference only. The actual product may vary. Nothing in this guide constitutes a warranty of any kind, express or implied.
Please visit http://consumer.huawei.com/us/support/index.htm for the recently updated hotline and email address in your country or region.
Privacy protection
To understand how we protect your personal information, please visit http://consumer.huawei.com/privacy-policy and read our privacy policy.