WORX Electric Pressure Washer WG606 Instruction Manual

June 6, 2024
Worx

WORX Electric Pressure Washer WG606 Instruction Manual

WG606

Illustration 1

Illustration 2

Illustration 3

Illustration 4

Illustration 5

Illustration 6

WARNING: This product can expose you to chemicals including lead and Di (2-ethylhexyl) phthalate (DEHP) which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www. P65Warnings.ca.gov.

GENERAL SAFETY WARNINGS

WARNING Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury.

Save all warnings and instructions for future reference.

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.

If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

IMPORTANT SAFETY INSTRUCTIONS

WARNING – When using this product basic precautions should always be followed, including the following:

  1. Read all the instructions before using the product.
  2. To reduce the risk of injury, close supervision is necessary when a product is used near children.
  3. Know how to stop the product and bleed pressures quickly. Be thoroughly familiar with the controls.
  4. Stay alert – watch what you are doing.
  5. Do not operate the product when fatigued or under the influence of alcohol or drugs.
  6. Keep operating area clear of all persons.
  7. Do not overreach or stand on unstable support. Keep good footing and balance at all times.
  8. Follow the maintenance instructions specified in the manual.
  9. This Product Is Provided With A Ground Fault Circuit Interrupter Built Into The Power Cord or Plug. If Replacement Of The Ground Fault Circuit Interrupter Or Cord Is Needed, Use Only Identical Replacement Parts.
  10. WARNING – Risk of eye injury. Spray can splash back or propel objects. Always wear properly rated eye protection such as safety goggles or face shield while spraying. (Safety glasses do not provide full protection.)

SAVE THESE INSTRUCTIONS

GROUND FAULT CIRCUIT INTERRUPTER PROTECTION This pressure washer is provided with a ground-fault circuit-interrupter (GFCI) built into the plug or the power-supply cord. This device provides additional protection from the risk of electric shock. Should replacement of the ground-fault circuit- interrupter or cord become necessary, use only identical replacement parts.

SERVICING OF A DOUBLE-INSULATED APPLIANCE
In a double-insulated product, two systems of insulation are provided instead of grounding. No grounding means is provided on a double-insulated product, nor should a means for grounding be added to the product. Servicing a double- insulated product requires extreme care and knowledge of the system, and should be done only by qualified service personnel. Replacement parts for a double-insulated product must be identical to the parts they replace.

EXTENSION CORDS

WARNING: Inadequate extension cords can be dangerous.

If the appliance cord is equipped with a GFCI, do not use extension cords. If the appliance cord is not equipped with a GFCI, the appliance and any extension cord used should be connected only to a GFCI-protected power source.

  1. Use only extension cords that have grounding-type plugs and female cord connectors that accept the plug from the product.
  2. Use only extension cords that are intended for outdoor use. These extension cords are identified on the packaging or on the cord by a marking “Acceptable for use with outdoor appliances; store indoors while not in use.”
  3. Use only extension cords having an electrical rating not less than the rating of the product.
  4. Do not use a damaged extension cord. Examine ex tension cord before using and replace if damaged.
  5. Do not abuse extension cord and do not yank on a cord to disconnect.
  6. Keep cord away from heat and sharp edges.
  7. Always disconnect the extension cord from the receptacle before disconnecting the product from the extension cord.
    WARNING – To reduce the risk of electrocution, use only a GFCI-protected extension cord or plug into GFCI outlet. Keep all connections dry and off the ground. Do not touch plug with wet hands.

ADDITIONAL SAFETY WARNINGS

  1. The electric supply connection shall be made by a qualified electrician and comply with IEC 60364-1. It is recommended that the electric supply to this appliance should include either a residual current device that will interrupt the supply if the leakage current to earth exceeds 30 mA for 30 ms or a device that will prove the earth circuit.
  2. WARNING: This appliance has been designed for use with the cleaning agent supplied or recommended by the manufacturer. The use of other cleaning agents or chemicals may adversely affect the safety of the appliance.
  3. WARNING: Do not use the appliance within range of persons unless they wear protective clothing.
  4. WARNING: High pressure jets can be dangerous if subject to misuse. The jet must not be directed at persons, live electrical equipment or the appliance itself.
  5. Do not direct the jet against yourself or others in order to clean clothes or foot-wear.
  6. Disconnect from the electrical power supply before carrying out user maintenance.
  7. High pressure cleaners shall not be used by children or untrained personnel.
  8. To ensure appliance safety, use only original spare parts from the manufacturer or approved by the manufacturer.
  9. WARNING: High pressure hoses, fittings and couplings are important for the safety of the appliance. Use only hoses, fittings and couplings recommended by the manufacturer.
  10. Do not use the appliance if a supply cord or important parts of the appliance are damaged, e.g. safety devices, high pressure hoses, trigger gun.
  11. Water that has flown through backflow preventers is considered to be non-potable.

SYMBOLS

SYMBOLS

COMPONENT LIST

  1. SOAP TANK CAP
  2. TELESCOPING HANDLE RELEASE BUTTON
  3. ON/OFF SWITCH
  4. DECLOGGING NEEDLE
  5. WATER INLET ADAPTER
  6. NOZZLES (25°/40°/SOAP)
  7. TURBO NOZZLE
  8. WATER PUMP
  9. NOZZLE COUPLER
  10. LANCE
  11. HIGH PRESSURE HOSE
  12. WAND
  13. LOCK-OUT
  14. TRIGGER
  15. SOAP TANK
  16. POWER CORD HOLDER
  17. POWER CORD
  18. RESET BUTTON (SEE FIG. G)
  19. TEST BUTTON (SEE FIG. G)
  20. O-RING (SEE FIG. B1)

Not all the accessories illustrated or described are included in standard delivery.

TECHNICAL DATA

TECHNICAL DATA

TECHNICAL DATA Continued

ACCESSORIES

ACCESSORIES

We recommend that you purchase your accessories listed in the above list from the same store that sold you the tool. Refer to the accessory packaging for further details. Store personnel can assist you and offer advice.

OPERATING INSTRUCTIONS

NOTE: Before using the tool, read the instruction book carefully.

INTENDED USE

The electric high pressure washer is intended for residential cleaning projects-from porch to patio, driveways and decks, boats, pavers, bricks, BBQs and more.

ASSEMBLY & OPERATION

ASSEMBLY & OPERATION Table 1

ASSEMBLY & OPERATION Table 2

ASSEMBLY & OPERATION Table 2

ASSEMBLY & OPERATION Table 4

MAINTENANCE

Remove plug from the socket before carrying out any adjustment, servicing or maintenance.
Inspect the product for damaged or worn parts before each use. Do not operate it if you find damaged or worn parts. Contact your supplier or the manufacturer for replacement parts.

Power cord maintenance
If the electrical cord is damaged, do not attempt to repair yourself; call the Worx solutions center for further assistance.

Pump maintenance
Inspect the pump frequently whether any leaking occurs around the pump seal. If leaking occurs, please contact the solutions center for further assistance.

Nozzle maintenance
Remove the nozzle from the lance, then remove any possible obstructions using the included declogging needle (See Fig. O).Then use a garden hose to rinse the nozzle by backwashing.

WARNING: Any other servicing should be performed by an authorized service representative.

STORAGE

  1. Disconnect the water source. Turn on the pressure washer for a few seconds until the remaining water flows out. Then turn it off quickly.
  2. Unplug the power supply and wind power cord on the tool. (See Fig. M1)
  3. Disconnect the high pressure hose and the garden hose (not supplied) .Then wind high pressure hose. (See Fig. P1) Insert the Wand and lance separately into the Wand Holder and lance holder. (See Fig. P2)
  4. Store in a frost free area with a temperature above 0°C(32°F).

TROUBLESHOOTING

TROUBLESHOOTING

www.worx.com

Copyright © 2021, Positec. All Rights Reserved.
AR01564401

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals