XPOWER FC-100 Air Circulator, Carpet Dryer Owner’s Manual

Air Circulator Owner’s Manual
Model:
FC-100, FC-200, FC-300, FC-420
(115V 60HZ)

Read and save these instructions before use

Safety Instructions

WARNING – READ AND SAVE THIS INSTRUCTION BEFORE USING THIS PRODUCT.
The user of electrical products may create hazards that include, but are not limited to injury, fire, electrical shock. Failure to follow these instructions may damage and/or impair its operation and void the warranty.

• Before operating, remove all packaging material and check for any damage that may have occurred during shipping or any missing items.
• Check the household power supply to ensure it matches the appliance’s specifications.
• DO NOT operate any fan with a damaged cord or plug. Discard the fan or return it to an authorized service facility for examination and/or repair.
• Use only on GFCI protected receptacles. Please contact a qualified electrician for verification and/or installation of a GFCI receptacle if necessary.
• DO NOT run cord under carpeting. DO NOT cover the cord with throw rugs, runners, or similar coverings. DO NOT route cord under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over.
• To reduce the risk of fire or electric shock, DO NOT use this fan with any solid-state speed control device.
• DO NOT touch this appliance or the plug with wet hands or while standing in water.
• DO NOT operate the appliance in any pooled water.
• DO NOT use the product in areas where gasoline, paint, or other flammable goods and objects are used or stored.
• DO NOT insert or allow objects to enter any ventilation or exhaust opening as this may damage the appliance and void the warranty.
• DO NOT cover the air inlet or outlet on the appliance.
• DO NOT direct the airflow at human faces or bodies.
• DO NOT allow children to play with this appliance.
• AUTOMATICALLY OPERATED DEVICE – To reduce the risk of injury, disconnect from the power supply before servicing.
• Remove the power cord from the electrical receptacle by grasping and pulling on the power cord plug-end only, DO NOT pull the cord directly.
• DO NOT attempt to repair or adjust any electrical or mechanical functions of this appliance, as this may cause danger and void the warranty.
• If the appliance is damaged or malfunctions, DO NOT continue to use it. Unplug the product from the electrical outlet. Refer to the troubleshooting guide or contact XPOWER.
• Store in a dry area, away from exposure to sunlight, extreme temperature, and humidity, or other extreme environments, when not in use.
• For model FC-100 / FC-200, DO NOT stack more than six units of this appliance. For model FC-300 / FC-420, DO NOT stack more than five units of this appliance.
• An electronic instruction manual can be obtained through the manufacturer’s website www.xpower.com.

Items Included

* For model FC-100/FC-200/FC-420 only.
The exact appearance of the products might be slightly different from the diagram.
** For model FC-300 only.

Parts Description

(1) Front Grille Cover
(2) Motor
(3) Housing
(4) Capacitor
(5) Housing Handle
(6) Switch Plate*/ Switch and Timer Plate**
(7) Rack Handle| (8) Rubber Washer
(9) Rack
(10) Fan
(11) Rear-End Cover
(12) Rear Grille Cover
(13) Power Cord
---|---

* For model FC-100 / FC-200 / FC-300 only.
** For model FC-420 only.

Air Circulator Introduction

• XPOWER Air Circulators are designed to offer efficient air circulation and ventilation with high and long-distance focused airflow.
• It’s perfect for air circulation and ventilation in janitorial/sanitation jobs, air condition control, and more.

Installation and Operation Guide

**Installing the Rack***

1. Fit both rubber washers onto bolts on both sides of the unit.
2. Align the rack onto the air circulator.
3. Fasten the connection with the rack handle.

Switch Plate

Four-Speed Switch ( For model FC-100/FC-200/FC-300  only)

• Turn to the “ OFF ” position to switch the Air Circulator OFF. Turn to any speed position to switch the Air Circulator ON.
• Turn clockwise to set the desired speed. There are 4 speeds from 4, 3, 2, 1. “4 ” is the highest speed and “ 1 ” is the lowest speed.

Five Speed Switch (For model FC-420 only)

• Turn to the “ OFF ” position to switch the Air Circulator OFF. Turn to any speed position to switch the Air Circulator ON.
• Turn clockwise to set the desired speed. There are 5 speeds from 5, 4, 3, 2, 1. “5 ” is the highest speed and “ 1 ” is the lowest speed

Timer Switch

• Turn clockwise to set a timer for minutes count down to an automatic stop.
• The timer can be set for up to 180 minutes (3 hours).
• When the timer reaches the “ 0 ” position, the unit stops working. On the “ ON ” position, it will work constantly.

Adjust Operation Position

• The Air Circulator features 360° Rotation. Tilt Air Circulator to desired angle and screw on rack handles to secure the position.

**Use without Rack***

• Uninstall the rack and place the Air Circulator on a level surface.

• For model FC-420 only.
  Transportation

Lift with Handle

• Lift the Air Circulator with the handle on the top.

User Maintenance Instructions

Frequent maintenance is recommended on this appliance. Failure to follow the maintenance instructions may cause the failure of the appliance and void the warranty.

• When not in use, unplug and store the appliance in a dry and cool indoor place. Make sure it’s out of reach of children.
• Before performing any maintenance or cleaning, always disconnect the Air Circulator from its power source.
• Use a damp cloth to wipe the surface of the housing. Do not clean the unit with water directly.
• Check if the grille covers are clean. Remove dirt or any other objects that could block the air inlet and air outlet.

Fasten the Rack Handles

• To prevent possible injury, when you finish using this appliance, please position the Air Circulator

UPRIGHT.

• Fasten the rack handle to lock the position of the Air Circulator.

Organize the Power Cord

• Wrap the power cord around the housing.
• Clip the cord to the cord clip on the plug shown above.

Stack Multiple Units

• Stack the Air Circulators on the sides. Align the air inlets of both Air Circulators.
  WARNING

• For model FC-100 / FC-200, DO NOT stack more than six units of this appliance.

• For model FC-300 / FC-420, DO NOT stack more than five units of this appliance.

• The stacking function is not secure during transportation.

Troubleshooting Guide

PROBLEM

| POSSIBLE CAUSE|

SOLUTION

---|---|---
Air Circulator does not start| No electricity.| Check for power supply.
The power cord is not properly plugged in.| Remove and reconnect the power cord.
The timer switch is set to the “0” position.| Set the timer switch to the “ON” position.
The unit runs but the speed is abnormal| The Air inlet or air outlet is blocked.| Remove blockage.

If troubleshooting does not resolve your problem, please contact XPOWER or other parties authorized by XPOWER for further instructions.

Technical Specification

MODEL NUMBER

| FC-100| FC-200| FC-300|

FC-420

---|---|---|---|---
Voltage/Frequency| 115 V~60 Hz
Amperage| 0.6 A| 1.0 A| 1.5 A| 2.8 A
Motor Power| –| –| 1/4 HP| 1/3 HP
Rated Airflow| 1100 CFM| 1300 CFM| 2100 CFM| 3600 CFM
Speed Control| 4 Speeds| 5 Speeds
Timer| Yes
Cord Length| 6 ft. / 1.8 m| 10 ft. / 3.0 m| 15 ft. / 4.5 m
Housing| PP| ABS
Unit Dimension(L) x (W) x (H)| 16.1 x 8.9x 14.2 in. /41.0 x 22.5 x36.0 cm| 17.3 x 8.9x 15.4 in. /44.0 x 22.5 x39.0 cm| 18.6 x 9.4 x19.2 in. / 47.2x 23.9 x 48.8cm| 21.9 x 9.8x 22.5 in. /55.6 x 24.9 x57.1 cm
Unit Weight| 9.7 lbs. / 4.4kg| 10.1 lbs. / 4.6kg| 13.0 lbs. / 5.9kg| 23.4 lbs. /10.6 kg
Safety Certification| ETL / C-ETL

If your product(s) is not listed above, please visit www.xpower.com for more information.

XPOWER Limited Warranty (USA)

1 YEAR LIMITED WARRANTY
XPOWER-branded products purchased in the U.S. from authorized distributors include a 1-year limited warranty. Contact XPOWER to confirm warranty information about your product(s).
This limited warranty covers defects in materials and workmanship in your XPOWERbrandedproducts, purchased in the U.S. ONLY. Local warranty policy (if any) in your country will cover products purchased outside the theU.S.
IMPORTANT:

1. Please finish the online warranty registration before usage. Visit www.xpower.com/service-support/warranty-registration.
2. This Limited Warranty applies with its own timeliness. Contact XPOWER or visit www.xpower.com for more information.

Items mentioned but not limited to below are not covered by warranty:

1. Power cord, filters, or any other components considered as “consumable parts” by XPOWER.
2. Normal wear and tear.
3. Problems that result, directly or indirectly, at XPOWER’s sole discretion, from:
   (3.1) External causes such as accident, abuse, misuse, or problems with electrical power supply.
   (3.2) Disassembling, servicing, or modification not authorized by XPOWER.
   (3.3) Usage that is not accordant with product instructions stated in the Owner’s Manual.
   (3.4) Failure to follow the product instructions or lack of necessary maintenance stated in the Owner’s Manual.

Before contacting XPOWER, please try one or more of the following:

1. Consult this Owner’s Manual and follow the instructions of the troubleshooting guide.
2. Access www.xpower.com for more advice and information that could be helpful to address your problems.

If you need additional assistance from XPOWER, please:

1. Email info@xpower.com.
2. Call XPOWER U.S. Customer Service Department at 855-855-8868 or other numbers provided on www.xpower.com.
3. Visit XPOWER U.S. Head Office at 240 Clary Ave., San Gabriel, CA 91776 or the most current address provided on www.xpower.com.

Please also have your original proof of purchase and the serial number(s) of your product(s) ready when you contact XPOWER.
If you are instructed to return the unit for service or replacement, please:

1. Request a RMA (Return-Merchandise-Authorization) number.
2. Use the original or equivalent packaging, prepay shipping charges at your own expense to the address provided by XPOWER, with the RMA number on the shipping label or the packaging.
3. Include all the original parts and components.

XPOWER will inspect, assess and advise the repairs needed and applicable cost if any.
For products under warranty, we will pay to ship the repaired or replaced product(s) to you if you use an address within the Contiguous United States. Otherwise, we will ship the product(s) to you at your own expense.

XPOWER Manufacture, INC.
240 Clary Avenue
San Gabriel, CA 91776 USA
www.xpower.com 
1-(855)-855-8868
info@xpower.com
Read and save these instructions before use

Index: NA-1-A9
Edition: 2.0.Alpha

References

• XPOWER Manufacture – XPOWER Manufacture
• XPOWER Manufacture – XPOWER Manufacture

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>