VANMASS CTVK13 Car Mount User Manual
- June 6, 2024
- VANMASS
Table of Contents
VANMASS CTVK13 Car Mount
Overview
Installation Steps
Tips for Placing the Dashboard Pad
Before installing the mount on uneven or textured dashboard, please firstly
stick the gel pad on the dashboard (only one-time use). Tear off the red
protective sticker on the pad, stick it on the dashboard, press it firmly for
over l minute t hen let it rest for 1-3 days to have strong stickiness.
Please wait for 24 hours to use the dashboard pad after placing.
Tips for Using the Suction Cup
- Clean the dashboard or windshield where you need to install the car phone mount with a alcohol wool or a wet cloth, wait for it to dry.
- After attach the suction cup, press down the suction cup lock totally to fix it.
- It will reduce the adsorbability when stick the suction cup on the curved surface, plush cloth surface or uneven surface.
- It is not recommended to attach the suction cup to leathers, walls or film-coated surfaces since the suction cup is designed with strong suction power which may cause surface damage.
- If t he suction cup is used frequently in high temperature, low temperature or humid condit ions, the adsorption forces would be lower (Please avoid to exposit it to the sun directly.
- If the suction is not sticky enough after usage, please take down the suction cup base and wash it with warm water. It will be sticky again after drying.
- Please guarantee t he suction cup is covered by plastic w rap if the suction cup holder is removed.
Tips for Removing the Suction Cup
The suction cup is recyclable, it can be removed in the following way:
-
Pull up the lever.
-
Pull the tab on the suction up to allow air to get into it then
stick a plastic putty knife, floss(at your own risk) underneath to break the seal -
Once the seal is broken you will be able to remove it easier.
-
Take out the grip nut on the mount, assemble it with suction up.
-
Find a suitable place, attach the car mount.
Using Steps
-
Press the release button on the back of the car mount then the clamp arms open automatically
-
Put the phone in the car mount then press the clamp arms to grasp the phone.
-
After using, please press the release button again to open the clamp arms and take out the mobile phone as shown in the picture.
Specifications
| Product Name | Car Mount |
|---|---|
| Model | CTVK13 |
| Applicable Places | Windshield, Dashboard |
| Package List | Car Mount xl, Package List Suction Cup x 1, Dashboard Pad X 1, |
User Manual xl
The parameters above are derived from the laboratory ofVANMASS®. The actual parameters would be different because of products and other factors. The image shown here is indicative only.
Attentions
- Avoid dropping.
- Do not disassemble.
- Please install the car mount on a suitable place before driving, do not operate and adjust the car mount during driving.
- Do not install the car mount in places which interfere with airbag or driving.
- Keep the car mount away from children.
Email:[email protected]
www.vanmasslife.com
VANMASS© trademark 1s registered In the USA and other countries. All rights
reserved Designed In H.K Made in China.
Documents / Resources
|
VANMASS CTVK13 Car
Mount
[pdf] User Manual
CTVK13, Car Mount
---|---