VANMASS EZ11CTBK1A Car Phone Mount User Manual

VANMASS EZ11CTBK1A Car Phone Mount User Manual

service@vanmasslife.com

www.vanmass.com

Overview

Installation Steps

Tips for Placing the Dashboard Pad

Before installing the mount on uneven or textured dashboard, please firstly stick the dashboard pad (only one-time use). Tear off the red protective sticker on the pad, stick it to the dashboard, press it hard for over 1 minute then let it rest for 1-3 days to have high strong stickiness.

After installing the dashboard pad, please wait for 24 hours before using it.

Tips for Using the Suction Cup

1. Clean the dashboard or windshield where you need to install the car phone mount with alcohol pads or a wet cloth, wait for it to dry.
2. After attaching the suction cup, press down the suction cup lock totally to fix it.
3. It will reduce the adsorbability when sticking the suction cup on the curved surface, plush cloth surface or uneven surface.
4. It is not recommended to attach the suction cup to leathers, walls or film-coated surfaces since the suction cup is designed with strong suction power which may cause surface damage.
5. If the suction cup is used frequently in high temperature, low temperature or humid conditions, the adsorption forces would be lower (Please avoid to expose it to the sun directly).
6. If the suction cup is not sticky enough after usage, please take it down and wash it with warm water, It will be sticky again after drying.
7. Please ensure the suction cup is covered by plastic wrap once removed.

Tips for Removing the Suction Cup

The suction cup is reusable, it can be removed in the following way:

1. Pull up the lever.
2. Pull the tab on the suction up to allow air to get into it, stick a plastic putty knife and floss (at your own risk) underneath to break the seal.
3. Once the seal is broken you will be able to remove it easier.

Assembly of Mount

1. Take out the grip, assemble it with suction up.
   

2. Find a suitable place, attach the car mount.
   

Using Steps

1. Press the quick release button, the clamp arms automatically pop open.
   

2. If you have a larger size phone, please pull down the adjustable bottom tray on the car phone holder according to the phone size to place your phone suitably. Then fix the phone in the same way like step 3, so that the phone could be clamped firmly.
   

3. Place your phone and find the press position (a dent place with tiny microdots on the clamp arms) to push, tighten up the clamp arms to hold your phone firmly.
   

4. After using, please press the quick release button again to open the clamp arms and take out the mobile phone as shown in the picture.
   

Specifications

The parameters above are derived from the laboratory of VANMASS®. The actual parameters would be different because of products and other factors. The image shown here is indicative only.

Attentions

1. Avoid dropping.
2. Do not disassemble.
3. Please install the car mount on a suitable place before driving, do not operate or adjust the car mount during driving.
4. Do not install the car mount in places which interfere with airbag or driving.
5. Keep the car mount away from children.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>