VANMASS Gravity Car Phone Mount User Manual
- June 6, 2024
- VANMASS
Table of Contents
**VANMASS Gravity Car Phone Mount User Manual
**
Overview
Installation Steps
Tips for Placing the Dashboard Pad
Before installing the mount on uneven or textured dashboard, please firstly
stick the dashboard pad (only one-time use). Tear off the red protective
sticker on the pad, stick it to the dashboard, press it hard for over 1 minute
then let it rest for 1-3 days to have high strong stickiness.
After installing the dashboard pad, please wait for 24 hours before using it.
Tips for Using the Suction Cup
- Clean the dashboard or windshield where you need to install the car phone mount with alcohol pads or a wet cloth, wait for it to dry.
- After attaching the suction cup, rotate its base completely to fix the suction cup.
- It will reduce the adsorbability when sticking the suction cup on the curved surface, plush cloth surface or uneven surface.
- It is not recommended to attach the suction cup to leathers, walls or film-coated surfaces since the suction cup is designed with strong suction power which may cause surface damage.
- If the suction cup is used frequently in high temperature, low temperature or humid conditions, the adsorption forces would be lower (Please avoid to expose it to the sun directly).
- If the suction cup is not sticky enough after usage, please take it down and wash it with warm water (no soapy water or other liquids). It will be sticky again after drying.
- Please ensure the suction cup is covered by plastic wrap once removed.
Tips for Removing the Suction Cup
The suction cup is reusable, it can be removed in the following way:
- Rotate to unlock the suction cup.
- Pull the tab on the suction cup to allow air to get into it, stick a plastic putty knife and floss (at your own risk) underneath to break the seal.
- Once the seal is broken you will be able to remove it easier.
Assembly of Mount
-
Take out the grip, assemble it with suction up.
-
Find a suitable place, attach the car mount.
Using Steps
-
Insert the phone into the car mount, the clamp arms would catch the phone automatically, then the car mount is ready to use.
-
After usage, please take out the phone as shown in the picture.
Specifications
Product Name
|
Car Mount
---|---
Model
|
CTVK19
Applicable Places
|
Dashboard; Windshield; Tables and so on.
Package List
|
Car Mount ×1,
Suction Cup ×1,
Dashboard Pad ×1,
User Manual ×1
The parameters above are derived from the laboratory of VANMASS®.
The actual parameters would be different because of products and other
factors. The image shown here is indicative only.
Attentions
- Avoid dropping.
- Do not disassemble.
- Please do not use the phone horizontally on the car mount; otherwise, the phone would slide off easily.
- The car mount cannot be compatible with phones under 4.7inch (such as iPhone 5, iPhone 5S, and so on).
- Please install the car mount on a suitable place before driving, do not operate and adjust the car mount during driving.
- Do not install the car mount in places which interfere with airbag or driving.
- Keep the car mount away from children.
Shenzhen Lanmiao Technology Co., Ltd.
ADD: RM1207. BLK C. Zhantao Technology BLDG. Minzhi Avenue. Minzhi ST. Longhua
DIST. Shenzhen. China
Email: service@vanmasslife.com
www.vanmasslife.com
VANMASS° trademark is registered in the USA and other countries. All rights
reserved. Designed in H.K.
Made in China
VMPI01011A
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>