VANMASS 2023 Car Phone Mount User Manual
- June 14, 2024
- VANMASS
Table of Contents
VANMASS 2023 Car Phone Mount
Installation Instructions
Phone Mount Assembly
- Unscrew the nut from the phone holder
- Insert the nut into the ball joint
- Push the ball joint into the groove of the holder
- Make sure the ball joint is fully in the groove and then tighten the nut
Installation Spot Optional Installation Spots
Practical Tips
Leather or textile dashboard
NOT compatible, in case of any damage. In extreme summer heat: It is
recommended to install the suction cup away from the direct sunlight.
Clean the flat attaching surface
- Please make sure the attaching surface is flat, curved mounting surfaces reduce adhesion.
- Wipe the attaching surface, wet tissue first, and dry tissue later.
Suction Cup Installation
- Peel off the protective film
- Firmly press the suction cup for l O seconds
- Keep pressing while pressing down the suction lock
Phone Mount Adjustment
Please wait 15 minutes before placing your phone, for higher adhesion.
Phone Mount Usage
Release the arms
Clamp the arms
FAQs
How to make the suction cup stick again?
Please rinse the suction cup bottom, air dry it, clean the attaching surface and then install the suction cup directly on a flat spot.
Do I need to return the product for a replacement or refund?
No, because our product has a 36-month free warranty for any product issues.
Any other questions like below, please reach our service at service@vanmasslife.com
Suction cup remove tips, product improvement suggestions.