RODE WIGO Wireless GO Compact Wireless Microphone System User Guide

: June 6, 2024
: Rode

Table of Contents

OVERVIEW
SET UP
TRANSMITTER – TX
- RECEIVER – RX
SPECIFICATIONS
Read User Manual Online (PDF format)
Download This Manual (PDF format)

RODE WIGO Wireless GO Compact Wireless Microphone System User Guide

OVERVIEW

The Wireless Go is a compact wireless microphone system that operates in the 2.4GHz spectrum. The kit includes a transmitter with an internal microphone and a receiver with 3.5mm TRS output.

SET UP

Press and hold the power button for 3 seconds to turn on the RX (receiver).
Press and hold the power button for 3 seconds to turn on the TX (transmitter).
The units will already be paired and start transmitting audio, the transmitter will be using the internal microphone.
Clip on the supplied windshield if required If desired, plug in a compatible external microphone and the TX will automatically switch the audio input.
Connect the 3.5mm TRS output of the RX to a camera’s microphone input or similar audio device.

TRANSMITTER – TX

Power Button

Press and hold the power button for 3 seconds to turn on the unit
Press and hold the power button for 3 seconds to turn off the unit
Single press to turn on when the device is in charging mode

Internal Microphone

The transmitter will use the internal microphone if there is not an external microphone plugged in On board processing optimised for the human voice

Microphone Input

Standard 3.5mm TRS microphone input Supplies 2.8V plug-in power for compatible microphones “Power” and “Link” LED’s

Power LED

Solid = internal battery is above 20% Slow
flash = internal battery is below 20% Rapid
flash = internal battery is below 10% Double
flash = Charging through USB (solid when 100% charge is reached)

Link LED

Solid = Paired and transmitting to an RX Slow
flash = Not connected to the RX or out of range Rapid
flash = in pairing mode (will time out after 3 seconds)
Off = TX is in charging mode and not transmitting to a receiver

USB-C

Standardised USB-C port
Used for charging with USB power supplies and is able to connect to a computer for future firmware updates
The power LED will display charging mode if the unit is plugged into power while off, a quick single press the power button will turn on the TX

RECEIVER – RX

Power Button

Press and hold the power button for 3 seconds to turn on the unit
Press and hold the power button for 3 seconds to turn off the unit
Single press to turn on when the device is in charging mode

“dB” Button

Press the “dB” button to cycle through the three audio output levels (0dB, -12dB, -24dB)
Set the level according to the requirements of the device receiving the audio. I.e. portable recorder, smartphone, camera, etc.
The RX will remember the selection chosen for future use

Link Button

The RX and TX will come pre-paired out of the box If pairing is required
Press and hold the button for 3 seconds
The signal strength icon on the screen will start flashing
Single press the power button on the TX
The TX and RX should pair immediately

Audio output

Standard 3.5mm TRS output
Multi-mono signal

USB-C

Standardised USB-C port
Used for charging with USB power supplies and is able to connect to a computer for future firmware updates
The screen will display charging mode if the unit is plugged into power while off, a quick single press the power button will turn on the RX