RODE CASTERDUO Multi Tracks Recorder User Guide
- June 1, 2024
- Rode
Table of Contents
RODE CASTERDUO Multi Tracks Recorder
- Connect the included power supply to your RØDECaster Duo, press the adjacent red power button and follow the start-up walkthrough
- Connect your microphones to the XLR inputs on the rear and adjust the corresponding faders to increase or decrease the input level
- Connect your headphones to the 1/4-inch outputs on the rear and adjust the corresponding knobs to increase or decrease headphone volume
- View the online user guide for more information on how to master your RØDECaster Duo
- Download RØDE Central to customise SMART Pads, transfer recordings, configure settings and update firmware for your RØDECaster Duo: rode.com/apps/rode-central
NORTH AMERICA
The RØDECaster DUO must not be co-located or operated in conjunction with any
other antenna or transmitter.
The device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used by the instructions may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and the receiver
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help
This equipment complies with FCC radiation exposure limits outlined in an
uncontrolled environment. Changes or modifications not expressly approved by
RØDE could void the user’s authority to operate the equipment.
For the USA: The frequency stability of all transmission frequencies of
U-NII-1, U-NII 2A, U- NII 2C and U-NII-3 meet the requirements of 47 CFR FCC
Part15.407(g), and the manufacturer declares that their transmission is
maintained at
Band U-NII-1, U-NII 2A, U-NII 2C and U-NII-3.
For Canada: The frequency stability of all transmission frequencies of
U-NII-1, U-NII
2A, U- NII 2C and U-NII-3 meets the 47 CFR
FCC Part15.407(g) requirements and the manufacturer states that their transmissions remain within the U-NII-1, U-NII 2A, U-NII 2C and U-NII-3 bands. This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference
- This device must accept any interference, including interference that may cause undesired operation of the device.
RADIATION EXPOSURE STATEMENT
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment shall be installed and operated with a minimum distance of 20cm between the radiator & body.
Radio Frequency Exposure Statement for Canada
The device has been evaluated to meet general RF exposure requirements. The
device can be used in mobile exposure conditions. The minimum separation
distance is 20cm.
EU COMPLIANCE STATEMENT
Hereby, RØDE Microphones declares that the radio equipment type RØDECaster DUO
complies with Directive 2014/53/EU. The full text of the EU Declaration of
Conformity is available at the following internet address:
https://info.rode.com/rodecaster-duo For details on EU representatives go to
http://en.rode.com/distributors
CAUTION
The RØDECaster Duo has been designed to be used with the provided power
supply, as the provided power supply only. Stop using the power supply unit
and any cables if:
- There is any damage to the charging port, power connector or power cord
- The power supply unit is exposed to excessive moisture or liquids are spilled into the power supply unit
- The power supply unit enclosure is broken
POWER SUPPLY UNIT SPECIFICATIONS
- Model Name: YDS-PD030A
- Frequency: 50-60 Hz
- Line Voltage: 100-240 Vac
- Output Ratings: 20Vdc 1.5A; 15Vdc 2.0A;
- 12Vdc 2.5A; 9Vdc 3A; 5Vdc 3A
Note 1
“Exceeding 0.1 wt %” and “exceeding 0.01 wt %” indicates that the percentage
content of the restricted substance exceeds the reference percentage value of
the presence condition.
Note 2
“○” indicates that the percentage content of the restricted substance does
not exceed the percentage of the reference value of presence.
Note 3
The “−” indicates that the restricted substance corresponds to the exemption.
FCC ID: 2AEAN-RCDUO
CANADA
IC: 20091-RCDUO
CAN: ICES-3 (B) / NMB-3 (B)
NEW ZEALAND
R-NZ
SOUTH KOREA
ID: R-R-R72-RCDUO
Company Name: RØDE Microphones
Model: RØDECaster Duo
Country of Origin: Australia
To prevent possible hearing damage, do not listen at high volume levels for long periods.
RØDE Microphones
107 Carnarvon St, Silverwater NSW 2128, Australia
Authorised UK Representative: RØDE UK, Unit A, 23-25 Sunbeam Rd, London
NW10 6JP, United Kingdom
Authorised EU Representative: RØDE EU, Neukirchner Str. 18, 65510 Hünstetten,
Germany
SCAN FOR MORE INFO
View the user guide to learn more.
References
- Where To Buy | RØDE Microphones
- RØDE Microphones | Premium Microphones & Audio Equipment
- RØDE Central | RØDE Companion App | RØDE
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>