BOGEN RPK82 Rack Mounting Kit Installation Guide
- June 6, 2024
- BOGEN
Table of Contents
Model: RPK82
TPU35B/60B/100B
Rack Mounting Kit
Installation
The TPU amplifiers are designed for wall-mount applications, but can also be
mounted in a standard 19″ rack using the included rack adapter brackets.
To mount the amplifier in a 19″ rack, it is first necessary to attach the rack
adapter brackets to the amplifier flanges (see Figure above) . Start the four
1/2″ truss-head self-tapping screws into the two small round holes in each of
the adapter brackets.
Be certain to secure the screws from the correct side of the brackets. The
brackets should mirror each other so that they can be installed on opposite
sides of the amplifier. From behind the amplifier, slip the rack adapter, with
screws, through the opening in the keyhole slots and slide them up into the
keyhole slots. Tighten the screws securely. Lift the amplifier up to the front
of the rack and secure it to the rack with the necessary screws (not
included). The amplifier will protrude out from the front of the rack.
NOTE: The amplifier will produce heat during operation which will rise and may cause problems for temperature-sensitive equipment mounted above it. Mount the amplifier near the top of the rack so that no other equipment will be above it. If this is not possible, then allow at least 12″ of open space above the amplifier and 4″ below for adequate air circulation.
Specifications are subject to change without notice.
© 2000 Bogen Communications, Inc.
Part No. 54-2031-01E 0912
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>