KYVOL Vigoair HD3 Ultrasonic Cool Mist Humidifier User Manual

June 6, 2024
KYVOL

KYVOL -logo

KYVOL Vigoair HD3 Ultrasonic Cool Mist Humidifier-

Ultrasonic Cool Mist Humidifier
User Manual

Please read all the instructions before using them and keep them for future reference.

IMPORTANT SAFETY INSTRUCTIONS

Please read these IMPORTANT SAFETY INSTRUCTIONS before using Vigoair HD3. You may avoid some issues during the use of the product by doing so, but following the instructions completely to operate the humidifier is not a must.

Before Using the Humidifier

KYVOL Vigoair HD3 Ultrasonic Cool Mist Humidifier-1

KYVOL Vigoair HD3 Ultrasonic Cool Mist Humidifier-2

KYVOL Vigoair HD3 Ultrasonic Cool Mist Humidifier-3

  • Please always place the humidifier on a smooth, flat, lint-free, non-metallic, waterproof, and level surface; avoid direct sunlight.

KYVOL Vigoair HD3 Ultrasonic Cool Mist Humidifier-4

• Always place the humidifier .≥2 feet (60 cm) above the floor, and ) ≥12 inches (30 cm) away from the wall, other appliances, or wooden furniture.

KYVOL Vigoair HD3 Ultrasonic Cool Mist Humidifier-5

When Using the Humidifier

KYVOL Vigoair HD3 Ultrasonic Cool Mist Humidifier-6

KYVOL Vigoair HD3 Ultrasonic Cool Mist Humidifier-7 After Using the Humidifier

KYVOL Vigoair HD3 Ultrasonic Cool Mist Humidifier-8

PACKING LIST

  • Humidifier Vigoair HD3 x 1
  • Cleaning Brush x 1
  • Dustproof Sponge x 1
  • User Manual x 1

SPECIFICATIONS

Model Vigoair HD3
Operating Voltage AC220-240V; 50/60Hz
Rated Power Min.:15W/Max.:30W
Water Tank Capacity 4.5L/1.18Ga I
Dimensions 375x208x168mm/14.76×8.19×6.61inches
Net Weight 1555g/54.8oz

PRODUCT OVERVIEW

KYVOL Vigoair HD3 Ultrasonic Cool Mist Humidifier-10

KYVOL Vigoair HD3 Ultrasonic Cool Mist Humidifier-12

OPERATION GUIDE

Add Water

KYVOL Vigoair HD3 Ultrasonic Cool Mist Humidifier-13

Important

  • If the tap water is too hard, we recommend using filtered or distilled water to avoid white dust. DO NOT use hot water.
  • DO NOT add any essential oils or medicinal tablets into the Water Tank.
  • DO NOT add water into the Base or through
  • DO NOT move the humidifier while the Water Tank is full of water to avoid leakage or Base

KYVOL Vigoair HD3 Ultrasonic Cool Mist Humidifier-14

Power ON/OFF And Mist Adjustment

  1. PIug the Power Cord into a socket.

KYVOL Vigoair HD3 Ultrasonic Cool Mist Humidifier-15

Low Water Protection

When there is not enough water in the Water Reservoir, the Water Level Indicator will turn red. The humidifier stops misting to prevent it from overheating and damaging the Atomizer.

MAINTENANCE AND CARE

Important

  • DO NOT submerge the Base in the water.
  • Make sure the water does not enter the Base through the Air Outlet, Air Inlet or Control Knob.
  • DO NOT wash any part of this humidifier in the dishwasher; otherwise, it will damage the humidifier.

Daily Maintenance

Step 1:

Turn off the humidifier and unplug the Power Cord from the socket. Step 2:

Drain water from the Water Tank, Water Reservoir, and Base.

Weekly Maintenance

  1. To properly clean your humidifier, we recommend that you remove scale and disinfect the humidifier separately.
  2. DO NOT mix vinegar and bleach solution together. To avoid damage to the humidifier, do not use more than 1 teaspoon of bleach per gallon of water.
  3. Please make sure the white sealing ring on the Tank Cap is installed correctly after cleaning to avoid water leakage.

Scale Removal Instructions
Step 1 : Turn off and unplug the humidifier.
Step 2 :
1) Separate the Water Tank from the Base , then remove the Tank Cap. Make sure that the white sealing ring does not come off.
2) Drain water from the Water Tank and Base , then remove all accessories and set aside.
Step 3 :
1) Fill the Water Tank halfway.
2) Add in 1 teaspoon of undiluted distilled white vinegar.
3) Attach the T ank Ca p and shake for 15 seconds.
Step 4:
1 ) Place the Water Tank back to the Base.
2)
The vinegar solution will enter the Water Reservoir to loosen mineral scale on the Atomizer , Water Floater and the bottom of the Water Tank. Leave it for 15-20minutes.

Step 5:
1)
Uncap the Tank Cap and drain the solution.
2) Wipe the Atomizer and floater with a soft cloth to remove loose mineral deposits.
Step 6:
Flush both the Water Reservoir and Water Tank until the smell of vinegar ( for scale removal) or bleach solution ( for disinfection, see below) is gone.

KYVOL Vigoair HD3 Ultrasonic Cool Mist Humidifier-18

Disinfection Instructions
Step 1:
Follow steps 1 to 2 in the previous section for scale removal.
Step 2:
1)
Fill the Water Tank halfway.
2) Add 1/2 teaspoon of bleach.
3) Attach the Tank Cap and shake for 15 seconds.
4) Place the Water Tank back to the Base. The bleach solution will enter and disinfect the Water Reservoir and the other components. Leave it for 15-20 minutes.
Step 3:
Follow steps 4 to 6 of the previous section for scale removal to complete the disinfection of the humidifier.
Dustproof Sponge Cleaning
Clean the Dustproof Sponge (located at the bottom of Base) with water or detergent once a month, then put it back in place after cleaning.

KYVOL Vigoair HD3 Ultrasonic Cool Mist Humidifier-19

End-Of-Season Care and Storage

  1. Follow the cleaning instructions when the humidifier will not be used for at least one week, or at the end of the season. Remove all accessories used in the humidifier. Allow the humidifier and accessories to dry completely before storing it.
  2. NOT store water in the Base, Water Reservoir or Water Tank.
  3. Pack the humidifier safely and store it in a cool, dry place.

TROUBLESHOOTING GUIDE

  • If you need any further assistance, please feel free to contact us at support@kyvol.com.
  • Failure to keep the humidifier clean and free of mineral deposits may affect the operation of it.

KYVOL Vigoair HD3 Ultrasonic Cool Mist Humidifier-20

Issue Possible Solution
The Water Level Indicator is off. The humidifier is not plugged in. Make

sure the humidifier is properly plugged into a socket.
No power from the power outlet.| Try to use other power outlets.
The humidifier is not turned on.| Check if the Control Knob is turned to ON/MIN.
The Water Level Indicator stays red.| No water in the

Water Reservoir.

pass through to the Base.

| Make sure the (1;Spring is fixed correctly to the bottom of the tank so that water can p
3,Water Floater was stuck.| Adjust the C3 Water Floater to a horizontal position and make sure it can rise with water.
The Water Level Indicator is green but there is no or little mist produced.| No enough water inside the tank.| Refill and re-install the Water Tank.
Mist level is set too low.| Adjust the humidifier to the maximum mist.
Mineral buildup on the Atomizer.| Check if any air comes out from the Nozzle. If not, then clean water scale on the Atomizer as instructed.
The Base might be overfilled.| Remove the tank, empty the Base, then place the filled tank on the empty Base.

Tank leakage| Tank may be damaged.| Check for possible cracks in the tank. If yes, please

replace it.

---|---|---
Tank Cap is not tightened securely.| Tighten the Tank Cap.
O N / Spring was stuck.| Make sure the (!;Spring is fixed correctly to the bottom of the tank so that water can pass through to the Base.
(Z)Sealing Ring was not installed on Tank Cap.| Make sure the ( . ?)Sealing Ring has been installed on the Tank Cap. Please

contact us if it is lost.

The mist makes the surrounding tables or floors damp. Condensation occurs around humidifier or on windows/walls.| Mist level is set too high for the room size.| 1. Check if the room is too humid and adjust the humidifier to a lower mist. 40%-60% works best.

2. Open door and windows, or change to a larger room.

Air Inlet was blocked.

Make sure the humidifier is

| Make sure the humidifier is placed on a hard flat surface of ≥2 feet above the floor and ≥12 inches away from the wall. Make sure the Nozzle is not facing the wall or window.
Low indoor temperature leads to liquefaction.| Adjust the room temperature to 25°C / 77°F.

The humidification is too poor.| Mist level is set too low for the room size.| 1. Adjust the humidifier to the maximum mist.

2. Close door or windows to reduce air ventilation, or change to a smaller room.

---|---|---
Air Inlet was blocked.| Make sure the humidifier is placed on a hard flat surface of ≥2 feet above the floor and ≥12 inches away from the wall. Make sure the Nozzle is not facing the

wall or window.

Low indoor temperature leads to liquefaction.| Adjust the room temperature to 25°C / 77°F.
White dust appears or the black coating on the Base flakes off.| The tap water may contain too much minerals.| Please replace it with filtered or distilled water.
Strange odor| Please clean the humidifier.| 1. Please make sure to clean the humidifier according to the instructions.

2.  Leave the empty Water Tank in a cool place for 12 hours without covering

Tank Cap.

Strange water noise| Water is going down to the Water Reservoir.| This is normal while it is working.
Humidifier is getting too hot.| The humidifier works for too long.| Please power it off and put it in a well-ventilated place for

10 minutes.

CAUTION

RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS
The symbol indicates AC voltage
RECYCLING
This product bears the selective sorting symbol for Waste electrical and electronic equipment (WEEE). This means that this product must be handled pursuant to European directive 2012/19/EU in order to be recycled or dismantled to minimize its impact on the environment. User has the choice to give his product to a competent recycling organization or to the retailer when he buys a new electrical or electronic equipment. This product can be used across EU member states.
EU Compliance Statement: Shenzhen VanTop Technology & Innovation Co., Ltd. hereby declares that this device is in compliance with the essential requirements and other relevant provisions of the Low Voltage Directive 2014/35/EU and EMC Directive 2014/30/EU. A copy of the EU Declaration of Conformity is available online at https://doc.vantop.com/.

EU Compliance Statement: Shenzhen VanTop Technology & Innovation Co.. Ltd. hereby declares that this device is in compliance with the essential requirements and other relevant provisions of the Low Voltage Directive 2014/35/EU and EMC Directive 2014/30/EU.

A copy of the EU Declaration of Conformity is available online at https://doc.vantop.com/.

Users should only operate the Vigoair HD3 once they have understood all the following important safety instructions. Users who have a disability and need assistance are responsible for seeking support and ensuring their own safety in line with the instructions given in this manual.

  • Children should be supervised to ensure that they do not play with the appliance. ‘Unplug the appliance during filling and cleaning.

  • Please confirm the composition and quantity of solution to be used during maintenance. If salt is included, it is recommended not to use excessive amounts of solution.

  • The appliance is not to be operated from a d.c supply – If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

CUSTOMER SUPPORT
North America: support@kyvol.com
United Kingdom: support.uk@kyvol.com

https://qrs.ly/uebdpq7

@kyvolglobal

KYVOL -qr1

https://qrs.ly/rzbdzpm

www.kyvol.com

https://qrs.ly/wtbdzpo

@ kyvol_globa I

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals