CMP 25597-200-000 Deck Jet With Adjustable Flow Nozzle Instruction Manual
- June 6, 2024
- CMP
Table of Contents
DECK JET WITH ADJUSTABLE FLOW NOZZLE INSTALLATION INSTRUCTIONS & PRODUCT
MANUAL
25597-200-000
25597-200-900
Read this manual completely before attempting installation.
WARNING
This product is must be installed and serviced by a pool and spa professional.
These instructions must be followed exactly to ensure the proper functionality
of the part.
SAVE THESE INSTRUCTIONS!
SPECIFICATIONS
Determine the proper size of the main feed pipe:
- Use 1-1/2” pipe for up to 8 deck jets
- Use 2” pipe for up to 12 deck jets
- Use 2-1/2” pipe for up to 16 deck jets
INSTALLATION
-
Install a ball valve on the main feed pipe near the pump to adjust the total water pressure delivered to the deck jets.
-
Reduce the piping to a 3/4” pipe. When installing more than one deck jet it is necessary to create an equal pressure loop to equalize the pressure in the line.
-
The body is designed to allow for 3/4” plumbing with a straight pipe or an elbow. Use only PVC/ABS glue to secure the pipe to the body.
-
Anchor the deck jet body and protective cover so that the top is level with the height of the finished deck.
a. Use black cover to protect deck jet while working on the pool and laying the deck.
b. Remove cover after the deck has been installed. -
Remove the cover, wrap the threaded plug with Teflon tape, and install it into the deck jet body.
a. Be sure not to over-tighten.
b. Replace the cover.
c. Leave the plug installed and keep the pipe pressurized during installation. -
Once the deck is finished, remove the protective label from the cover, remove the cover, and remove the plug. Turn on the pump, open the valves and run water through the lines to remove any debris that may have collected.
-
Wrap the threads on the jet nozzle base with Teflon tape and install them in the body (tighten using the wrench provided until the nozzle is fully seated in the body – do not overtighten).
-
Adjust the position of the nozzle and adjust any valves in the line to achieve the desired flow.
a. To balance the flow, the nozzle may be turned by hand or by using the wrench provided by inserting over the nozzle and turning to adjust the flow (clockwise for more flow, counter-clockwise for less).
b. CAUTION D o not overtighten nozzle when adjusting flow. -
If the stream is disrupted, remove the jet nozzle and check for debris.
WINTERIZATION
To winterize the deck jet, first, remove the Jet Nozzle with the wrench. Next,
blow air through the lines, and install the plug
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>