Audio-Technica Line + Gradient Condenser Microphone AT897 User Manual

**AT897

User Manual / **Line + Gradient Condenser Microphone

Thank you for purchasing this product. Before using the product, read through the user manual to ensure that you will use the product correctly. Please keep this manual for future reference.

Safety precaution

Although this product was designed to be used safely, failing to use it correctly may result in an accident. To ensure safety, observe all warnings and cautions while using the product.

Cautions for the product

• Do not subject the product to a strong impact to avoid malfunction.
• Do not disassemble, modify or attempt to repair the product.
• Do not handle the product with wet hands to avoid electric shock or injury.
• Do not store the product under direct sunlight, near heating devices, or in a hot, humid, or dusty place.

Battery caution

• Keep the battery out of the reach of children.

• Observe correct polarity as marked.

• Do not expose the battery to excessive heat such as sunshine, fire, or the like.

• Always consider the environmental issues and follow local regulations when disposing of batteries.

• Remove the depleted battery immediately.

• The danger of explosion if the battery is incorrectly replaced.
  Replace only with the same or equivalent type.

• Use only a disposable R6/LR6 (AA) manganese or alkaline battery.

• Do not use a rechargeable battery.

• Do not use a different battery type or model.

• Do not use a leaking battery. If battery leakage occurs, avoid contact with the skin. If contact occurs, immediately wash thoroughly with soap and water.

• If battery leakage comes into contact with your eyes, immediately flush with water and seek medical attention.

Connection procedure

This product requires phantom power.

1. Connect the output terminals of the microphone to a device that has a microphone input (balanced input) compatible with a phantom power supply.
   • If the connected device does not support phantom power, insert one specified battery into the product.

2. When attaching to devices such as video cameras, install the included O-rings to the microphone to ensure a tight fit between the microphone holder and microphone.
   • Install both O-rings to the location where the microphone attaches to the holder.

How to insert the battery

Rotate the grip and insert the specified battery into the battery holder. Be sure to check the (+) and (-) polarity indications. If phantom power is supplied with a battery inserted, the phantom power has priority.

Switch settings

To reduce the pickup of low-frequency ambient noise (such as traffic, air- handling systems, etc.), room reverberation, and mechanically coupled vibrations, turn ON ( ) the low-cut filter switch located on the side of the product.

Specifications

• 1 Pascal = 10 dynes/cm 2= 10 microbars = 94 dB SPL
  For product improvement, the product is subject to modification without notice.

Polar pattern

Dimensions

(Unit: mm)

Frequency response

LEGEND

|

0°, 50 cm

|

———–

| 0°, 50cm,
---|---|---|---
0°, 50 cm, Low cut

Included accessorie s

Output terminals

Warranty (Please be sure to read the notes below.)
For USA Only

End-User LIMITED WARRANTY information for the USA is available at www.audio- technica.com/usawarranties. You may also contact Audio-Technica U.S., Inc. to request a written copy of the Limited Warranty at 1-330-686-2600 or via mail at 1221 Commerce Drive, Stow, OH 44224.

Audio-Technica Corporation
2-46-1 Nishi-naruse, Machida, Tokyo 194-8666, Japan
www.audio-technica.com
©2021 Audio-Technica Corporation
Global Support Contac t: www.at-globalsupport.com
Made in Japan
142311672-01-01
ver.1 2021.09.01

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>