GOAL ZERO 32012 Crush Light LED Lantern User Guide
- June 6, 2024
- GOAL ZERO
Table of Contents
GOAL ZERO 32012 Crush Light LED Lantern User Guide
BEFORE FIRST USE:
Take the Crush Light Chroma out of DEMO mode by pressing the on/off button
for 10 seconds.
GET TO KNOW YOUR GEAR
-
Rechargeable by Sun
-
USB Rechargeable
-
Hour Runtime on Lowest Setting
-
Weatherproof IPX4 Rated
HOW IT WORKS
TIP:
Fully charge the crush light before its first use
3 WHITE MODES + CANDLE FLICKER.
- Push the On/Off Button to select brightness modes.
- Press 1X for High
- Press 2X for Medium
- Press 3X for Low
- Press and hold for 2 seconds for candle flicker
- Press and hold for 3 seconds to turn it off
Still in DEMO MODE? See the front cover for instructions.
RUNTIME
| LUMENS| CHARGE TIME
---|---|---
High
| 3 hour| 60 lumens| USB source|
3.5 hours
Medium| 6 hours| 25 lumens| Built-in panel|
20 hours
Low
| 35 hours| 6 lumens| –| –
Candle Flicker| 3.5 hours| –| –|
–
RECHARGE YOUR CRUSH LIGHT LANTERN
Recharge from USB or solar panel.
Know it’s charging with the LED indicator light next to the charging port turns red. The Crush Light is fully charged when the light turns green.
Helpful Recharging Hint:
Place your Crush Light so the solar panel is directly angled at the sun. For
the best charge, reposition it throughout the day so it stays at the best
angle.
TECHNICAL SPECIFICATIONS
Battery
Cell chemistry| Li-ion Polymer
Cell capacity| 1.85Wh (3.7V, 500mAh)
Lifecycles| Hundreds of cycles
Shelf-life| Charge every 3-6 months
Solar
Rated Power| ~0.12W
Cell type| Monocrystalline
Ports
USB port (input)| 5V, up to 0.5A (2.5W max)
General
Durability| IPX4
Weight| 3.2oz (91g)
Dimensions (Open)| 4.95 x 4.95 x 3.9in (125 x 125 x 100mm)
Dimensions (Closed)| 4.95 x 4.95 x 0.6in (125 x 125 x 15mm)
Operating usage temp.| 32-104 F (0-40 C
Certs|
Warranty| 12 months
Be sure to activate your warranty at goalzero.com/warranty
GOAL ZERO HEADQUARTERS
675 West 14600 South
Bluffdale, UT 84065
1-888-794-6250
Designed in the U.S.A.
Made in China
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>