BRYDGE B08D6XQX14 W-Touch Wireless Precision Touchpad User Manual
- June 6, 2024
- Brydge
Table of Contents
BRYDGE B08D6XQX14 W-Touch Wireless Precision Touchpad User Manual
POWER
To power on, slide power switch on back of unit from left to right and
release. LED will turn green for three seconds to indicate touchpad is on.
To power off, slide power button to left and release.
PAIR
Once touchpad is on, slide the power switch to the right (towards the LED) and
hold for three seconds. LED will flash blue until the touchpad is successfully
paired.
On your device under Bluetooth settings select Brydge W-Touch.
CHARGE
To charge your Brydge W-Touch, insert the supplied USB-C cable into the
charging port.
The battery is charging when the LED flashes red. The LED will turn off when
the battery is fully charged. CHARGE
Thank you for purchasing a Brydge product. This product comes with a 1-year
limited hardware warranty on the terms and conditions set out in this document
and at www.brydge.com/warranty. All Brydge warranties are non-transferrable
and are only available to the original end-user of the product. Warranties do
not apply to products purchased from online vendors unauthorized to sell
Brydge-branded product. If a defect arises during the warranty period, cease
using the product and contact Brydge. To obtain warranty service, visit
www.brydge.com/support or call +1
435-604-0481. Brydge, at its sole
discretion and option, will (1) repair the product at no charge using new
parts or parts that are equivalent to new in performance and reliability, or
(2) replace or exchange the product with a product of equivalent functionality
and value. Brydge offers free return shipping on any approved warranty claims.
A shipping label will be provided to you if you are within the United States.
If you are outside the United States, Brydge will reimburse your return
shipping to a maximum of US$15.00 after providing a copy of the shipping
receipt.
Australia Only: Our goods come with guarantees that cannot be excluded under
the Australian Consumer Law. You are entitled to a replacement or refund for a
major failure and compensation for any other reasonably foreseeable loss or
damage. You are also entitled to have the goods repaired or replaced if the
goods fail to be of acceptable quality and the failure does not amount to a
major failure.
Brydge Technologies LLC | 1912 Sidewinder Dr., Suite 104, Park City, UT 84060
USA
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions: (1) This device
may not cause interference. (2) This device must accept any interference,
including interference that may cause undesired operation of the device. This
equipment complies with IC RSS-102 radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter. This device complies
with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference. (2) This
device must accept any interference received, including interference that may
cause undesired operation. Changes or modifications not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment. This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the.
FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS
The battery shall not be exposed to excessive heat such as sunshine, fire or
the like. © 2020 Brydge. All Rights Reserved. Microsoft, the Microsoft logo,
Microsoft Surface, Surface, and the Microsoft Surface logo are trademarks of
the Microsoft group of companies. The Bluetooth word mark, and logos are owned
by Bluetooth SIG, Inc. Use of such marks by Brydge is under license. Brydge is
a trademark of Brydge Global Pte. Ltd. Other trademarks and tradenames are
those of their respective owners.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>