rega kyte stand adaptor User Manual
- June 6, 2024
- Rega
Table of Contents
rega kyte stand adaptor User Manual
Warning:
For user instructions in your language, please visit www.rega.co.uk and go to the download section of your chosen product page.
ASSEMBLY
Using the four Pozi screws supplied, simply hand tighten two screws through each of the stand adaptors into the corresponding threaded holes on the back of the speaker (as shown in the diagram). To ensure the stand adaptor is aligned correctly, place the speaker, with foot attached, on a flat surface before fully tightening to ensure the speaker will sit level in its final position.
IMPORTANT: NEVER place the speaker face down when fitting the feet, to avoid damage to the drive units.
POSITIONING
The KYTE stand adaptor now allows the use of third-party speaker stands. Imaging and bass response can be tuned by adjusting the distance of the speaker from the rear and side walls. As with all loudspeakers, this will be dependent on the size of room, flooring and furnishings therefore some simple experiments trying different distances will help optimise the performance to your surroundings. In general, more bass is produced if the cabinet is positioned closer to a structural wall.
ADAPTOR FEET (INCLUDED)
Your stand adaptor includes two rubber feet, factory fitted to the top of each base.
Also included are four optional feet for each adaptor to fit to the bottom of each base, allowing you to adjust them to your stand.
Website www.rega.co.uk
Rega Research Ltd.
6 Coopers Way Temple Farm Industrial Estate Southend-on-Sea, Essex SS2 5TE
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>