rega Fono MM MK5 Moving Magnet Phono Stage User Manual
- June 6, 2024
- Rega
Table of Contents
rega Fono MM MK5 Moving Magnet Phono Stage User Manual
- INPUT
- OUTPUT
- TURNTABLE EARTH
- AC SOCKET
POWERING UP
The Fono MM is turned on by pressing the on-off button located on the front, when the unit is active the Rega logo will glow RED.
WARNING : We advise you to turn the Fono on first, followed by the amplifier. This is because the power surge in the Fono could cause an audible, power on “thump” which may distress the speakers.
METHOD OF CONNECTION
INPUT : Connect the tonearm leads and earth (if used) to the input socket and to the earth terminal on the back of the Fono.
TURNTABLE EARTH : If the turntable or tonearm has a separate signal earth connection, this should be connected to the turntable earth terminal on the back of the unit.
OUTPUT : Connect the output socket of the Fono to the line input on the amplifier.
PLEASE NOTE : If you have an integrated amplifier with built in phono stage, DO NOT connect the Fono to this input.
POWER SUPPLY : Connect the Rega PS1 to the AC socket on the Fono back panel.
SPECIFICATIONS
Input sensitivity
1.7 mV (for 200 mV output)
Input loading
47 kΩ in parallel with 100 pF
Maximum input level
60 mV @ 1 kHz
Gain
41.1 dB @ 1 kHz
Output impedance
200 Ω
Recommended minimum output load resistance
5 kΩ
Frequency response (50 kΩ output load)
15 Hz (-3 dB) to 100 kHz
(-0.2 dB)
RIAA accuracy (50 kΩ output load)
Better than ±0.2 dB 100
Hz to 100 kHz
Power requirements
24 V AC at 80 mA maximum. Only to be used with Rega PS1.
WEEE COMPLIANCE
This symbol indicates that the electronic equipment bearing it should not be
disposed of as general household waste at the end of its life. The equipment
should be disposed of at a collection point for waste electrical and
electronic equipment in accordance with national legislation and Directive
2012/19/EU.
For more information about how to dispose of your waste electronic equipment,
please contact your local authority or retailer where you purchased the
product.
WARRANTY
All Rega products are covered by a lifetime warranty against manufacture defects. This warranty does not cover wear and tear. Any unauthorised modifications or failure to follow the Rega recommended guidelines may invalidate the warranty. If returning goods for inspection to your retailer, the original packaging must be used to preserve the warranty. Damage caused during transport due to incorrect packaging may invalidate your warranty. Replacement packaging is available from any Rega retailer. Your statutory rights are not affected.
IMPORTANT INFORMATION
Use only with the Rega PS1 power supply. Never expose the unit to rain or moisture. Do not open the case covers. There are no user serviceable parts inside.
SPECIFICATIONS (PS1)
Rega Research Ltd.
6 Coopers Way
Temple Farm Industrial Estate
Southend-on-Sea, Essex
SS2 5TE
FONO MM MK5
User Manual v1
MADE IN ENGLAND
SINCE 1973
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>