Skullcandy IndyANC Earbuds User Guide
- June 6, 2024
- Skullcandy
Table of Contents
Skullcandy IndyANC Earbuds User Guide
Charge Case
Charge Case
Auto Pair Mode
Auto Power- On
Power- On
Auto Power- Off
Power- Off
Charge Earbuds
Charge Earbuds
Pairing Mode
Pairing Mode ****
Left Side or Right Side *Off Mode
Pair New Device
Pair New Device “Indy ANC”
Power- On
Power- On
Left Side and Right Side
Power- On
Power- On
Left Side and Right Side
Play/Pause
Play/pause
Left Side or Right Side
Track Forward
Track Forward
Track Back
Track Back
Left Side
Volume Up
Volume Up Right Side
Pair Tile
Pair Tile
3 EQ Modes
Music, Movies, and Podcast
Change equalizer modes
Noise Cancellation
Active Noise Canceling (ANC) On/Off
Left Side or Right Side On and Off
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
ISED Compliance Statement
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development
ISED SAR Compliance Statement
This equipment complies with ISED radiation exposure limits set forth for an
uncontrolled environment. End user must follow the specific operating
instructions for satisfying RF exposure compliance. This transmitter must not
be co-located or operating in conjunction with any other antenna or
transmitter.
The portable device is designed to meet the requirements for exposure to radio
waves established by the ISED. These requirements set a SAR limit of 1.6 W/kg
averaged over one gram of tissue. The highest SAR value reported under this
standard during product certification for use when properly worn on the body.
Questions Visit: www.skullcandy.com
SIMPLIFIED EU DECLARATION OF CONFORMITY
Hereby, Skullcandy Internation GmbH declares that the radio equipment type
[Model: S2IYW] is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the
following internet address: skullcandy.eu/product-
documents
Speaker Driver: 6mm, Impedance: 32 Ohms, THD <3%@1KHz, Voltage Regulation: 5V, 500mA, Bluetooth® 5.0, Frequency Band: 2402MHz – 2480MHz, Maximum Power: 10mw, Weight: 63.5g
Skullcandy, ,and other marks are registered trademarks of Skullcandy,Inc. All rights reserved.
Maximum operating temperature 45ºC
Contains Li-ion battery. Battery must be recycled or disposed of properly
Made in China
Hardware Version: V1.4
Software Version: V3.0
MODEL : S2IYW
FCC ID : Y22-S2IYW
IC : 10486A-S2IYW
R-C-Sku-S2IYW
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>