Skullcandy STOMP XL Wireless Party Speaker User Guide
- May 15, 2024
- Skullcandy
Table of Contents
QUICK START GUIDE
STOMP™ XL
THE PORTABLE PARTY
FUNCTIONS
Power ON / OFF:
Press and hold the “O” button for 2s. If not connected to a Bluetooth® device
or connected but idle (not playing audio) the speaker will turn OFF
automatically after 15 min.
Play / Pause:
Press the “ ** ” button once to play or pause audio.
Volume Up:
Press “+” button to increase the volume.
Volume Down:
Press “-” button to decrease the volume.
Next Track:
Press and hold “+” button for 2s to skip track.
Previous Track:
Press and hold “-” button for 2s to go to last track.
Bluetooth® Pairing:
Press and hold the “Bluetooth®” button for 2s to enter Bluetooth® Pairing
Mode. The speaker will disconnect from any paired device and will become
available to pair to new devices. The speaker will stay in pairing mode for
60s, or until connected. Status LED will blink blue while in Bluetooth®
Pairing Mode.
True Wireless Stereo Pairing:
Press the “TWS” button on any two STOMP XL™ speakers to pair them together and
play audio in stereo. Status LED will be cyan to indicate Right channel and
yellow to indicate Left channel.
Exit True Wireless Stereo Mode:
Press the “TWS” button to exit TWS pairing.
SKDY Multi-link™ Transmitting:
First, connect to the STOMP XL™ speaker by BT, AUX, or USB-A audio input
connection. Double press the “Multi-link™” button to set the speaker as
transmitting. Any receiving speaker enabled SKDY Multi-link™ will now be able
to join. Status LED will be purple.
SKDY Multi-link™ Mode Receiving:
Single press the “Multi-link™” button to set the speaker as receiving (the
speaker will automatically disconnect from any paired Bluetooth® devices).
Status LED will be green. Up to 99 receiving speakers can be connected to a
single transmitting speaker.
Check Battery Status:
The 4 LED indicators show the battery level. Press and hold “+” and “-“
buttons together for 1s to initiate a voice prompt of the battery level.
Light Show Mode
Press and hold the “Light Show” button for 2s to turn the light show ON or
OFF. Single press the “Light Show” button to cycle between different light
show modes.
Strobe Light ON/OFF
Double press the “Light Show” button to toggle the strobe light ON or OFF.
Dual-Device Connection:
You can pair two transmitting devices (mobile phones for example) to the STOMP
XL™ speaker at the same time to DJ together. Pause the music on the first
device to play a song from the second device.
Charge Out:
While the speaker is ON, plug a USB-C™ or USB-A cable into the appropriate
port to begin charging your compatible portable device automatically.
CHARGING THE STOMP XL™
Use the USB-C™ cable included to connect the speaker to an appropriate power
source to begin charging. The LED indicators will show the battery is
charging. When all 4 LEDs are ON the battery is fully charged.
Warning:**
- To avoid damage to the speaker and battery, it is important to only use a power source that matches the power requirements listed on the speaker’s rating label.
- To avoid overheating, it’s recommended not to place the speaker in direct sunlight, especially while charging and playing music.
Battery status indication (not charging):
0-5% – speaker is OFF all 4 LEDs are OFF
5-10% – 1st LED blinks white, status LED blinks red
10-25% – 1st LED is ON white, other LEDs are OFF
25-50% – 1st + 2nd LEDs are ON white, other LEDs are OFF
50-75% – 1st + 2nd + 3rd LEDs are ON white, other LEDs are OFF
75-100% – All LEDs are ON white
Battery status indication (while charging):
0-25% – 1st LED blinks white, other LEDs are OFF
25-50% – 1st LED is ON white, 2nd LED is blinking.
Other LEDs are OFF
50-75% – 1st + 2nd LEDs are ON white, 3rd LED is blinking.
Other LEDs are OFF
75-99% – 1st + 2nd + 3rd LEDs are ON white, 4th LED is blinking.
Other LEDs are OFF
100% – All 4 LEDs are ON white
CONNECTION PRIORITY
AUX > USB > BT (Bluetooth®)
To play from an AUX source, simply plug in an AUX cable to the speaker and
your audio source device. It will automatically have priority over USB and BT.
To play from a USB source, plug in a USB flash drive and make sure that AUX is
disconnected. It will automatically have priority over BT (but not over AUX).
To play from BT source, connect a Bluetooth® enabled device and make sure that
AUX and USB are disconnected.
TROUBLESHOOTING
Factory Reset:
Press and hold “-” and “+” buttons at the same time for 10s to initiate
factory reset. The speaker will revert to factory settings and all previously
paired devices will be deleted. Status LED will blink between blue and red
while resetting.
Low Battery:
If the speaker’s battery is fully depleted, it may not turn ON immediately
even when connected to a power source. Please plug the speaker into an
appropriate power source and let it charge for at least 10 minutes before
turning it ON.
Speaker is not playing wirelessly:
If the speaker is not playing audio although it’s connected to a Bluetooth™
device, it may be because of the audio connection priority. Disconnect any AUX
or USB-A connections to the speaker and try again.
SPECIFICATIONS
Bluetooth® Version ：5.3
Battery Capacity: 11.1V 4000mAh
Charging Input: AC 110-220V
Playtime: 12 hours (Based on 80dBSPL(c) with light show OFF)
Charging Time: 4.5-5 hours
Operating Range: 10M
Audio Inputs: Bluetooth®, USB-A, Aux 3.5mm
Charging Outputs: USB-C, USB-A
Battery Standby Time: 365 Days
IPX Rating: IPX5 (Splashproof)
https://qrstud.io/muwgllp
SCAN FOR SUPPOR
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC/IC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
within 20cm minimum distance between the radiator & your body.
Canada warning:
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions: This device may
not cause interference. This device must accept any interference, including
interference that may cause undesired operation of the device.
MODEL: 2SKSK1851 1 YEAR WARRAN TY
Skullcandy.com
info.skullcandy.com/Support.
2024© Skullcandy is a registered trademark Marketed and distributed by Lifeworks technology Group LLC., New York, NY 10018. USB Type-A™, USB Type-C™ and USB-C™ are trademarks of USB Implementers Forum. The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Lifeworks Technology Group LLC. is under license. All brands are registered trademarks of their respective companies. *Actual product may differ slightly from images. Made in China.
Packaging Includes:
(1) STOMP™ XL Party Speaker
(1) 6ft. Power Cord
(1) Corded Microphone
(1) User Manual
STICKER PACK
Documents / Resources
|
Skullcandy STOMP XL Wireless Party
Speaker
[pdf] User Guide
STOMP XL, STOMP XL Wireless Party Speaker, Wireless Party Speaker, Party
Speaker, Speaker
---|---
References
- Help Center | Skullcandy
- Skullcandy Headphones, True Wireless Earbuds, Speakers & More - Skullcandy.com