Skullcandy Uproar Wireless User Manual

: June 2, 2024
: Skullcandy

Table of Contents

User Manual
- Skullcandy Uproar Wireless
Product Diagram
PAIR NEW DEVICE:
PAIRING MODE:
POWER-ON/OFF:
VOLUME UP:
VOLUME DOWN:
PLAY/ PAUSE
TRACK FORWARD:
TRACK BACK:
ANSWER/END:
CHARGE
FCC COMPLIANCE STATEMENT
IC Statement
- Read More About this Manual & Download PDF
Read User Manual Online (PDF format)
Download This Manual (PDF format)

User Manual

Skullcandy Uproar Wireless

Product Diagram

PAIR NEW DEVICE:

PAIR NEW DEVICE

PAIRING MODE:

Pairing – While power is off, hold the MFB until the LED alternates flashing BLUE and RED.
Un-pairing – Press and hold the volume up and volume down buttons until you hear two short tones.

PAIRING MODE

POWER-ON/OFF:

Power On – Press and hold the MFB until the LED flashes blue and the ascending tone plays through the headphones.

Power Off – Press and hold the MFB until the LED turns RED and the descending tone plays through the headphones.

POWER-ON/OFF

VOLUME UP:

Volume Up – Press the volume up button. A tone will sound at maximum volume.

VOLUME UP

VOLUME DOWN:

Volume Down – Press the volume down button. A tone will sound at minimum volume.

VOLUME DOWN

PLAY/ PAUSE

Pause – Press the MFB once to pause and once again to play.

PLAY-PAUSE

TRACK FORWARD:

Next Track – Press and hold the volume up button.

TRACK FORWARD

TRACK BACK:

Previous Track – Press and hold the volume down button.

TRACK BACK

ANSWER/END:

Answer Call – While paired, press the MFB once.

ANSWER/END

CHARGE

Charging –The LED will be Red while charging and turn Blue once fully charged.
Low Battery – The LED will flash Red and a tone will sound 4 times.

CHARGE

Hardware: V0.3
Software: V0.3
Bluetooth function: 2402MHz-2480MHz @ 9.28dBm
MODEL: Uproar Wireless

Speaker Driver: 40mm
Impedance: 32 Ohms
THD <0.1% (1mW/500Hz)
Weight: 123g.

FCC COMPLIANCE STATEMENT

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

This device may not cause harmful interference.
This device must accept interference, including interference that may cause undesired operation .

MODIFICATIONS NOT EXPRESSLY APPROVED BY THE MANUFACTURER COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT UNDER FCC RULES.

This equipment complies with the limits for a Class B digital device as specified in Part 15 of FCC Rules. These limits provide reasonable protection against radio and TV interference in a residential area. However, your equipment might cause TV or radio interference even when it is operating properly. To eliminate interference you can try one or more of the following corrective measures:

Reorient or relocate the receiving antenna.
Increase the distance between the equipment and the radio or TV.
Use outlets on different electrical circuits for the equipment and the radio or TV.
Consult your dealer or an experienced radio /television technician if the problem still exists.

Modifying or tampering with your system’s internal components can cause a malfunction and might invalidate the system’s warranty and sold your FCC authorization to operate This Class B 0..grIal apparatus compiles with Canadian ICES-003.