inhand VG710 AC/DC Adapter Installation Guide

June 6, 2024
Inhand

inhand VG710 AC/DC Adapter Installation Guide
inhand VG710 AC/DC Adapter

Introduction

1-Wire is a device communication bus system designed by Dallas Semiconductor Corp. that provides low-speed data, signaling, and power over a single conductor. It is typically used to communicate with small inexpensive devices such as digital thermometers and iButton devices. iButton® devices are small, durably packaged modules with globally unique digital addresses.

With its integrated 1-Wire interface, VG710 acts as bus master could communicate with iButton device or 1-Wire thermometer.

Users should first correctly install their 1-Wire device, and then they can check their 1-Wire device detail via VG710’s WebUI.

Install your 1-Wire device

The following figure shows 20-pin IO connector of VG710, which includes 1 Wire interface support.
Installation Instruction

The following table details the 20-pin IO connector function assignment, and pin 3 is reserved for 1-Wire application.

PIN| Terminal Name| PIN| Terminal Name| PIN| Terminal Name
---|---|---|---|---|---
1| 485-| 8| A14/D14| 15| DO1
2| CANL| 9| Al2/D12| 16| GND
3| 1-Wire| 10| GND| 17| A15/D15/WHEEL TICK
4| DO4| 11| 485+| 18| A13/D13
5| DO2| 12| CANH| 19| A11/D11
6| GND| 13| GND| 20| GND
7| A16/D16/FWD| 14| DO3| |

When install your 1-Wire device, you should connect its DQ pin to pin 3 of
VG710. Also you should connect its VDD and GND pins to GND pin of VG710. Make sure your installation is ready, and all these pin connections are OK.

Check your 1-Wire device detail

The following figure shows where you can check detail of your 1-Wire device. Check WebUI: Industrial >> 1-Wire

Check Instructions

No Connection

The Connection Status shows Disconnected if no 1-Wire device is connected or your 1-Wire device has not been correctly installed.

iButton device

If your iButton device is correctly installed, it shows as the following.
iButton device

1-Wire thermometer

If your 1-Wire thermometer is correctly installed, it shows as the following.
1-Wire thermometer

Note that it takes a little longer to retrieve the temperature, and you can enable page auto refresh to check the temperature changes.

The following example selects 5 seconds and then click Refresh button to enable page auto refresh.
1-Wire thermometer
Then page auto refresh will work and you will see the temperature changes.
1-Wire thermometer

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals