ELRO FS4610 Ultra Thin Smoke Detector With a 10-Year Battery Instruction Manual
- June 6, 2024
- ELRO
Table of Contents
ELRO FS4610 Ultra Thin Smoke Detector With a 10-Year Battery
INTENDED USE: FIRE SAFETY
ESSENTIAL CHARACTERISTICS: PASSED
Nominal activation conditions/ Sensitivity, Response delay (response me) and
Performance under fire condition – Operational reliability – Tolerance to
supply voltage – Durability of operational reliability and response delay,
temperature resistance, vibraration resistance, humidity resistance, corrosion
resistance, electrical stability
This smoke alarm is equipped with a self-test mechanism. At least once a month at a random moment, the device automatically checks the functionality of the sensor and the siren. During a successful test, the detector will beep and blink briefly. If problems are detected, the detector switches to error mode. Replace the device immediately if the error message occurs!
Overview LED & acous c signalling
Operating mode| Visual signal (flash)| Acoustic signal (beep)|
Description mode
---|---|---|---
Normal| 1 x per 40 second| None| Device is functioning properly
Self test| 1 x| 1 x| Device functions correctly
Manual test| 3 x| 3 x| Device functions correctly
Alarm| 1 x per second (3 x) / pause of 1,5 seconds| 1 x per seconds (3 x) /
pause of 1,5 seconds| Device is detecting smoke
Alarm silence| 1 x per 8 seconds| None| Smoke alarm signal is muted
Low battery warning| 1 x per 40 seconds| 1 x per 40 seconds| Battery is
running low
Low battery warning silence| None| None| Low battery warning is muted
Sensor fault warning| 1 x per 40 seconds| 1 x per 40 seconds| Sensor is not
functioning properly
Buzzer fault warning| 2 x per 40 seconds| None| Buzzer is not functioning
properly
Warnings:
- To prevent injury, this apparatus must be securely attached to the ceiling in accordance with the installation instructions.
- Batteries shall not be exposed to excessive heat such as sunshine and fire.
- Battery life shortens without monthly tests.
- Keep away from air conditioning/ventilation.
- Do not paint or cover the device.
- Consult local regulations.
Troubleshooting: False alarm is often caused by dust or steam. In case of
doubt: Leave the building and take ac on!
Additional mounting instructions: Corridor max width 3m: Max 15m between
2 alarms. Max. 7,5m to front side and alarms at edges/crossings of corridors.
Galleries: Length and width >2m and >16m², additional alarms below gallery.
Partial roof slopes: Flat ceiling ≤1m wide, consider as the roof slope.
Flat ceiling >1m wide, consider as flat ceiling.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>