GLOBAL INDUSTRIAL NK30-A Forklift Maintenance Platform Instruction Manual
- June 6, 2024
- GLOBAL INDUSTRIAL
Table of Contents
GLOBAL INDUSTRIAL NK30-A Forklift Maintenance Platform
NOTE: Owner and operator must read and understand this instruction manual before operation.
Product Description
THANK YOU FOR USING THIS WORKING PLATFORM. FOR YOUR SAFETY AND CORRECT OPERATION, PLEASE CAREFULLY READ THIS INSTRUCTION BEFORE USING IT.
NOTE : All of the information reported herein is based on data available at the moment of printing. The factory reserves the right to modify its own products at any moment without notice and incurring in any sanction. So it is suggested to always verify possible updates. Please carefully read this operation manual and ‘working platforms on forklift trucks guidance note PM28’ before use.
Instructions
This platform is specially designed matched with the forklift according to requirements of ‘working platforms on forklift trucks guidance note PM28’. It ensures your safety with its multiple safeguards. The operation is very convenient. Its folding structure makes it easy for transportation and storage.
Parameters
Model| Person Qty| Min. truck capacity| H×W×D (mm)|
Notes
---|---|---|---|---
NK30-A| single| 750kg| 1900×950×950| With lift and right gate
NK30-B
| single| 750kg| 1900×1200×1000| With lift and right gate
double| 1250kg| 1900×1200×1000| With lift and right gate
NK30-C
| single| 750kg| 1900×1000×1000| With lift and right gate
double| 1250kg| 1900×1000×1000| With lift and right gate
Installation
- Lift the safeguard and fix it with the back rail by the inner pin. Fix the back rail with the base by pins.
- Lift the front rail and open the left and right doors. Fix them by pins.
- Move the platform to get the fork holes in alignment with the forks of the forklift. Adjust the forks until they match the fork holes.
- Move the forklift to insert the forks into the fork holes. Fix the lever at the back of the platform.
- Reeve the chain through the bracket of forklift and fix the other end of the chain on the platform.
- Open the left or right door and equip the accessory. Put tools and devices into the platform and accessory. Then platform operator can enter the platform and closed the door.
- Check all the points that need to be fixed. Fix it if any hasn’t been fixed.
- Platform operator must check and wear the safety belt.
- Others keep away from the platform. Forklift driver move the truck to the appointed working place and lift the platform to the needed height. All controls should be locked except the lifting lever. The driver should not leave the forklift.
- When the work is finished, platform operator informs the forklift driver to lower the platform to the ground. Then the operator can take off the safety belt, accessory, tools and devices and open the door to get out. The forklift driver draws back forks from the platform. Finally, fold the platform according to the opposite steps of installation above.
Attention
- Operators of platform and forklift must be trained or authorized.
- Illumination of working place: illumination intensity shouldn’t be less than 500lx according to the illumination standard of CIE.
- Make sure there are no cables, steel rods, concrete pipe or other protrusions within the space where the platform lifts.
- It is prohibited for anyone to stand or pass under the platform.
- Platform operator must work according to the installation instructions above.
- Check the forklift of performance before use to ensure the safety.
- When the platform is lifted, it is prohibited to move the forklift forwards or backwards unless the safety is ensured and both platform operator and company safety director agree to.
EXPLODED VIEW & PART LIST
6 Folding Process
**
**
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>