TOTally wicked ARC-Sigma Vape Kit User Manual

June 6, 2024
TOTally wicked

totally wicked logo

TOTally wicked ARC-Sigma Vape Kit

TOTally wicked ARC-Sigma Vape Kit

YOUR ARC SIGMAArc sigma

REMOVING THE ATOMIZER HEADremoving head

PRIME THE ATOMIZER HEADprime head

REATTACH THE TANK BASEreattach

FILL THE TANKfill tank

ADJUST AIRFLOWadjust

TURN POWER ONturn power on

SET WATTAGEset wattage VAPINGvapingCHARGE THE BATTERYcharge
battery

USING YOUR ARC SIGMA

PRIMING THE ATOMIZER HEAD

It is important to “prime” a new atomizer head before first use. Failure to do so can damage the atomizer head. Remove the tank from the arc Sigma battery by unscrewing at the tank base. Turn the tank upside down, then unscrew the tank base from the glass section of the tank. Removethe atomizer head by pulling straight out, drip a few drops of e-liquid onto the cotton wick through the openings on the sides of the atomizer head, and push back into the tank. Screw the base back onto the tank and refit to the battery.

ATOMIZER HEAD LIFESPAN

Atomizer heads do not last forever and need to be replaced periodically. Lifespan is generally from a few days to several weeks, depending on power used, vaping style, flavour and type of e-liquid. A slight burnt taste, general loss of vapour production, or a reduction in flavour intensity can all be indicators that the atomizer head requires replacement.

FILLING THE TANK

Unscrew the top section of the GT Air Slim tank and fill the tank through one of the apertures either side of the central air hole. Do not allow liquid to enter the central air hole. Refit the top section of the tank.
Note : To avoid leaking, ensure an air gap of 2mm remains above the e-liquid after filling. After priming a new atomizer head and filling the tank, it is recommended to wait 5 minutes to ensure the atomizer head is fully saturated.

POWERING ON AND OFF

Press the power button 5 times in quick succession to turn the arc Sigma on. To turn the device off again, press the power button 5 times quickly.

SETTING THE CORRECT WATTAGE

The arc Sigma has adjustable wattage that can be set from 1 – 40W. Use the adjustment buttons on the battery to increase or decrease the wattage. We recommend a wattage of 11W with the supplied atomizer head but feel free to experiment to find your favourite setting.
Tip : Press and hold down either of the adjustment buttons to make speedy changes to the wattage.

VAPING
Press and hold the power button as you inhale the vapour, the screen will display a vape timer while the power button is held down.

ADJUSTING THE AIRFLOW
To adjust the airflow to your personal preference, rotate the airflow control ring located at the bottom of the tank. The more area exposed behind the slots in the airflow ring, the more open the air draw will be.

E-LIQUID LEVEL
To prevent the atomizer head from becoming dry and burning prematurely, ensure the e-liquid level does not drop below the cotton inlets on the atomizer head, visible through the glass section of the tank.

CHARGING THE BATTERY

To charge the battery, connect the charge port on the battery to a USB port or suitable wall adaptor with the supplied charging cable. The screen will display an animated battery icon while charging, once the battery is fully charged the screen will switch off completely.

REPLACING THE ATOMIZER HEAD
Remove the tank from the arc Sigma battery by unscrewing at the tank base. Invert the tank and unscrew the base. Remove the atomizer
head from the tank by pulling, and insert a new atomizer head. Before fitting a new atomizer head, remember that it will need priming as described in the section “Priming the Atomizer Head”.
Reminder : After priming a new atomizer head it is recommended to wait 5 minutes before vaping to ensure the atomizer head is fully saturated.

STEALTH MODE

If stealth mode is enabled, the display will not activate when pressing the power button to vape. The display will still activate whenever the adjustment buttons are pressed to make changes to wattage. To enable stealth mode, ensure the arc Sigma is switched on, then press and hold down the power and down adjustment buttons at the same time, the screen will display “Stealth ON” when enabled. Repeat the process to disable stealth mode, the screen will display “Stealth OFF” when disabled.

KEY LOCK MODE
Key lock mode prevents accidental changes to the wattage. If key lock mode is enabled, the screen will display “Lock” if the adjustment buttons are pressed. Adjustments to wattage
cannot be made until key lock has been disabled. To enable key lock mode, ensure the arc Sigma is switched on, then press and hold down both adjustment buttons at the same time, then screen will display “Lock” when enabled. Repeat the process to disable key lock mode, the screen will display “Unlock” when disabled.

ROTATING THE DISPLAY
Switch the arc Sigma off, then press and hold down both adjustment buttons at the same time to rotate the display 180°. Then switch the arc Sigma back on.

PUFF & VAPE DURATION

If the puff counter and vape duration display is enabled, the arc Sigma will display the number of the times the power button has been pressed to vape and total time spent vaping in
seconds. To enable the counter, quickly press the power button 4 times while the arc Sigma is switched on. Puff counter is displayed on the first row while vape duration is displayed on the second row. To reset the number of recorded puffs to zero, press and hold down the power and up adjustment buttons at the same time. To reset the vape duration to zero, press and hold down the power and down adjustment buttons at the same time. Quickly pressing the power button 4 times switches the arc Sigma back to wattage display mode.

PROTECTIONS

ATOMIZER HEAD PROTECTION
If the power button is held down for longer than 10 seconds while vaping, the screen will display “Over 10s” and the arc Sigma will refuse to power or produce any vapour. Releasing the power button will allow normal operation to resume.

LOW VOLTAGE PROTECTION
If battery voltage drops to 3.3V, “Lock” will be displayed onscreen and the arc Sigma will refuse to power or produce any vapour. Charge the battery using the steps outlined in “Charging the Battery” to unlock the arc Sigma allowing normal operation to resume.

LOW BATTERY ALERT
If battery drops to 10% charge, the power symbol on screen will flash continuously. This is a reminder the battery will need charging soon.

SHORT CIRCUIT PROTECTION
If an atomizer short circuit occurs, the screen will display “Atomizer short” and the arc Sigma will refuse to power or produce any vapour. Replacing the atomizer head should allow normal operation to resume. To replace the atomizer head follow the steps outlined in “Replacing the Atomizer Head”.

NO ATOMIZER DETECTED PROTECTION
If no atomizer head is detected, the screen will display “No atomizer” and the arc Sigma will refuse to power or produce any vapour. Ensure the atomizer head is fully pushed into the tank and the tank base is correctly screwed onto the tank, then fit the tank back ontothe battery. If the “No atomizer” message continues, replacing the atomizer head should allow normal operation to resume. To replace the atomizer head follow the steps outlined in “Replacing the Atomizer Head”.

TEMPERATURE ALERT
If the temperature of the arc Sigma exceeds the maximum safe operating temperature, the screen will display “Device Too Hot” and the arc Sigma will refuse to power or produce any vapour. Stop vaping and allow the arc Sigma to cool down for normal operation to resume.

CLEANING AND MAINTENANCE

The arc Sigma battery and tank connection can be cleaned by wiping down with tissue or a dry cloth. The tank can be cleaned by removing it from the battery, unscrewing the tank base from the glass section of the tank then removing the atomizer head. The entire tank and base can now be cleaned under hot running water. Allow the tank to fully dry before refitting the atomizer head into the tank. Reassemble the tank.
Note : Do not attempt to clean the atomizer head with water. Do not submerge the arc Sigma battery unit in water or allow it to get wet.

KIT CONTENTS

  • 1 x arc Sigma battery
  • 1 x GT Air Slim tank
  • 2 x GT 1.2ohm atomizer heads
  • 1 x USB cable
  • 1 x User manual

SPECIFICATIONS

ARC SIGMA BATTERY

  • Dimensions: 78mm (height) x 23mm (width) x 35mm (depth)
  • Weight: 105g
  • Battery capacity: 2600mAh integrated battery
  • Wattage range: 1 – 40 watts.
  • Voltage range: 0.5 – 8.0 volts
  • Thread type: Spring loaded 510 connection.
  • Atomizer resistance compatibility: > 0.4ohm – 3.0ohm.

GT AIR SLIM TANK

  • Dimensions: 52mm (height) x 16.5 (diameter)
  • Weight: 27.5g
  • Tank capacity: 2.0ml
  • Atomizer type: GT
  • Thread type: 510 connection
  • Atomizer head resistance: 1.2ohm
  • Airflow type: Bottom, adjustable Maximum refill nozzle diameter: 2.3mm
  • Suggested power: 5-16W

ADDITIONAL PRODUCT INFORMATION

There are no reported medical side effects with this product. If you believe you experience a side effect, please contact the manufacturer.

PRODUCT STORAGE AND BATTERY PRECAUTIONS

  • Store the arc Sigma e-cigarette and its accessories away from children whilst not in use.
  • Please only use the charging cable provided.
  • Please dispose of dead batteries in accordance with your country’s appropriate legislation.
  • Do not charge the battery in a damp environment, or in temperatures under 0°C or above 45°C.
  • Do not use the device in temperatures under -10°C or above 60°C.
  • Do not carry batteries in a pocket or bag with other metallic objects.
  • Do not attempt to repair a faulty arc Sigma battery as these are sealed units with no serviceable parts. Attempted repairs will void the warranty.

WARRANTY

The arc Sigma kit has a 6 months parts warranty, with the exception of atomizer heads, which are consumable items and covered by “dead on arrival” warranty only. The USB cable supplied has a 12-month warranty. If any parts are found to be faulty within this time please contact our customer service team, whose details are on the back page of this booklet and we will arrange for a replacement. We may require the goods to be returned for further investigation.

Manufactured in China under the authority of
Pillbox38 (UK) Ltd, Stancliffe Street,
Blackburn, Lancashire, BB2 2QR.
Tel: 01254 692244
www.totallywicked.co.uk

Documents / Resources

| TOTally wicked ARC-Sigma Vape Kit [pdf] User Manual
ARC-Sigma, Vape Kit
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals