ASRock 3U10G-F Rackmount Server Barebone Dual Socket User Guide
- June 6, 2024
- ASRock
Table of Contents
ASRock 3U10G-F Rackmount Server Barebone Dual Socket User Guide
IPMI (Intelligent Platform Management Interface) LAN
a.) Connect your System to Local Area Network via System’s MNG (dedicated IPMI LAN)port:
b.) For some ASRR Server Systems which support to NCSI function, you can also connect your System to Local Area Network via either System’s MNG or LAN1(shared IPMI LAN ) port:
To check if your System’s LAN1 support NCSI function, please refer to MB’s user manual.
For example, following is the MB’s user manual of 3U10G-F System:
You can find if LAN1 support NCSI or not in Specifications page.
IPMI LAN IP address
a.)Power-on your System and press “F2” or “DEL” to enter BIOS Setup Menu during the POST:
b.)Switch to Server Mgmt page and enter BMC Network Configuration:
c.)Assign and check IPMI LAN’s IP address. Figure’s IP address is assigned by DHCP (UEFI default), you can also assign it manually.
d.)You can also find IPMI LAN IP address during POST stage after IPMI LAN IP address is assigned.
Manage your System via IPMI over LAN (IOL)
From remote site (Linux):
a.)Please install ipmitool before IPMI function usage.
b.)After ipmitool installed, you can login IPMI (typically ASRR System’s IPMI
username/password for login is admin/admin ) and manage your System via
IPMI over LAN (IOL) in the console by the following:
For example, check System’s sensor reading:
For more IPMI usage in Linux, please refer to the following link: https://linux.die.net/man/1/ipmitool
BIOS Setup for Serial over LAN
a.)Power-on your System and then press “F2” or “DEL” to enter BIOS Setup Menu
during the POST.
b.)Switch to Advanced → Serial Port Console Redirection
c.) Modify SOL Console Redirection to “Enabled” (UEFI default=Disabled)
d.)Check Console Redirection Settings (required for remote control)
Operating System Setup for Serial over LAN (SOL)
a.)In Host site (Linux), follow Console Redirection setting to add the
following boot parameter in grub.cfg
“console=tty1 console=ttyS1,115200n8”
For example:
for CentOS,
♦ with UEFI boot(ASRR Server System default), please edit: /boot/efi/EFI/centos/grub.cfg
♦ with Legacy boot, please edit: /boot/grub2/grub.cfg
b.)In Remote site (Linux), please install ipmitool to realize remote control via SOL as well
Control your System from remote site via Serial over LAN (SOL)
From remote site (Linux) :
a.)open a console and input the following command to realize remote control via Serial over LAN:
# ipmitool -I lanplus -H -U admin -P admin sol activate
b.)and you can login System as System OS’s username/password to realize remote control via SOL
—– END —–
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>