LogTag UTREL30-16 Temperature Data Logger User Guide
- June 6, 2024
- LogTag
Table of Contents
Quick Start Guide
Version A
www.logtagrecorders.com
What’s included
Please check you have each of the items shown below before continuing with
setting up your UTREL30-16.
Battery Installation
The AAA batteries are the main power source for your UTREL30-16.
A USB cable is another power backup source if you wish to power the unit
permanently via the USB socket.
1. You will need a small Phillips (cross-shaped) screwdriver to remove the
cover on the back of the UTREL30-16 case.
Battery Installation continued
2. Once you have removed the battery cover, install the 2x AAA batteries.
Take note of the direction in which each battery must be installed.
3. Once both batteries are securely installed, replace the battery cover and
secure via the screw you used to open the cover.
Warning : Please note the UTREL30-16 will not start if AAA batteries are
low and there is no USB power.
Downloading LogTag Analyzer
To download the latest LogTag Analyzer, open your browser and navigate to:
https://logtagrecorders.com/software/LTA3/
1. Click ‘Go to downloads page’ to take you to the download page.
2. Click ‘Download Now’ to start the download.
3. Click ‘Run’ or ‘Save File’ then double-click the downloaded file to open
the LogTag Analyzer Setup Wizard.
Warning : Please ensure no other LogTag software is currently running on
your computer before running the Analyzer software.
Downloading LogTag Analyzer continued…
4. Follow the on-screen prompts to install LogTag Analyzer.
5. Click ‘Finish’ to exit the LogTag Analyzer Setup Wizard.
Note : If you already have LogTag Analyzer installed, please see whether you need to update to the latest version by clicking ‘Check the Internet for updates’ from the ‘Help’ menu.
Confi during your UTREL30-16
Connect your UTREL30-16 to the computer via the USB port. The USB socket on
the device is located on the bottom, protected by the cap.
1. Open LogTag
Analyzer.
2. Click ‘Configure’ from the ‘LogTag’ menu or click the ‘Wizard’ icon.
3. Adjust your logger configuration settings as required. For more
information on configuration settings, please refer to Configuring the
UTREL30-16 in the Product User Guide or press ‘F1’ for help from your
keyboard.
4. Click ‘Configure’ to upload the configuration settings to the logger.
5. Click ‘Close’ to exit the configuration page.
Starting your UTREL30-16
Please ensure you have connected an ST10 external probe to your device before
starting.
Please ensure you have connected an ST10 external probe to your device before
starting.
Press and hold the START/ CLEAR/STOP button.
STARTING will appear along with READY.
Release the button once READY disappears.
The UTRED30-16 now records temperature data.
The Logger will not start if:
• You release the button before READY disappears.
• You keep holding the button for more than 2 seconds after READY disappears.
• The backup battery is critically low and the logger is not connected to
power.
Downloading Results
Connect your UTREL30-16 to your computer via the USB cable provided. The USB
socket n the device is located on the bottom, protected by a rubber
seal.
A new device drive will appear in file explorer with the files containing the
recorded data.
Alternatively, you can follow the steps below:
1. Open LogTag Analyzer
2. Click ‘LogTag’ from the ‘Download’ menu or press ‘F4’
3. Click ‘Close’ to exit the download page
By default, auto-download is enabled in LogTag Analyzer so when you open the
program, data results will be displayed after connecting your UTREL30-16 to
your computer.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>