LogTag UTREL30-16 Dual Channel Low Temperature Recorder User Guide
- June 5, 2024
- LogTag
Table of Contents
LogTag UTREL30-16 Dual Channel Low Temperature Recorder User Guide
What’s included
Please check you have each of the items shown below before continuing with setting up your UTREL30-16.
Battery Installation
2. Once you have removed the battery cover, install the 2x AAA batteries.
Take note of the direction each battery must be installed.
3. Once both batteries are securely installed, replace the battery cover and secure via the screw you used to open the cover.
Warning: Please note the UTREL30-16 will not start if AAA batteries are low and there is no USB power.
Downloading LogTag Analyzer
To download the latest LogTag Analyzer, open your browser and navigate to:
- Click ‘Go To Downloads Page’ button
- Click ‘Download Now’ to start the download
- Click ‘Run’ or ‘Save File’ then double-click the downloaded file to open Analyzer Setup Wizard
- Once the Analyzer Setup Wizard is open, follow the on-screen prompts to install Analyzer onto your computer
- Click ‘Finish’ to exit the Setup Wizard
Warning: Please ensure no other LogTag software is currently running on your computer before running the Analyzer software.
Configuring your UTREL30-16
Connect your UTREL30-16 to the computer via the USB port. The USB socket on the device is located on the bottom, protected by the cap.
- Open LogTag Analyzer.
- Click ‘Configure’ from the ‘LogTag’ menu or click the ‘Wizard’ icon.
- Adjust your logger configuration settings as required. For more information on configuration settings, please refer to Configuring the UTREL30-16 in the Product User Guide or press ‘F1’ for help from your keyboard.
- Click ‘Configure’ to upload the configuration settings to the logger.
- Click ‘Close’ to exit the configuration page.
Note: Please ensure you have LogTag Analyzer version 3.1.15 onwards for configuration of the UTREL30-16 dual-sensor models.
Starting your UTREL30-16
Before starting, please ensure you have connected the ST10X external probe(s) into the correct Channel sensor port(s) you have configured to record from.
Note: The sensor cover can be inserted in an unused sensor port.
During Recording
To view more information about clearing alarms and resetting and reviewing trip statistics, please refer to the Product User Guide.
Downloading Results
Connect your UTREL30-16 to your computer via the USB cable provided. The USB socket on the device is located on the bottom, protected by a rubber seal.
A new device drive will appear in file explorer with the files containing the recorded data for the Channel(s) monitored.
Alternatively, you can follow the steps below:
- Open LogTag Analyzer
- Click ‘LogTag’ from the ‘Download’ menu or press ‘F4’
- Click ‘Close’ to exit the download page
By default, auto-download is enabled in LogTag Analyzer so when you open the program, data results will be displayed after connecting your UTREL30-16 to your computer
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>