LogTag UTRED30-16 Dual Channel Temperature Recorder or Data Loggers User Guide
- June 5, 2024
- LogTag
Table of Contents
LogTag® UTRED 30-16
Quick Start Guide
Version G – April 2022
www.logtag-recorders.com
What’s Included
Please check you have each of the items shown below before continuing with setting up your UTRED30-16.
Downloading LogTag Analyzer
To download the latest LogTag Analyzer, open your browser and navigate to:
https://logtagrecorders.com/software/LTA3/
- Click `Go To Downloads Page’ button
- Click `Download Now’ to start the download
- Click
Run’ orSave File’ then double-click the downloaded file to open Analyzer Setup Wizard - Once the Analyzer Setup Wizard is open, follow the on-screen prompts to install Analyzer onto your computer
- Click `Finish’ to exit the Setup Wizard
Warning: Please ensure no other LogTag software is currently running on your computer before running the Analyzer software.
Configuring your UTRED30-16
Connect your UTRED30-16 to your computer via the USB cable provided. The USB socket on the device is located on the bottom, protected by a rubber seal.
- Open LogTag Analyzer
- Click
Configure’ from theLogTag’ menu or click theWizard’ icon. Please select which Channel(s) you wish to log, inLog channels:’ setting. - Adjust your logger configuration settings as required. For more information on configuration settings, please refer to Configuring the UTRED30-16 in the Product User Guide or press `F1′ for help from your keyboard
- Click `Next’ to upload the configuration settings to the logger
- Click `Close’ to exit the configuration page
Note: Please ensure you have LogTag Analyzer version 3.1.15 onwards for configuration of the UTRED30-16 dual-sensor models.
Starting your UTRED30-16
Before starting, please ensure you have connected the ST100X external probe(s) into the correct Channel sensor port(s) you have configured to record from.
Press and hold the START/Clear/Stop button. STARTING will appear along
with READY.
Release the button once READY disappears.
The UTRED30-16 now records temperature data.
The Logger will not start if:
- You release the button before READY disappears.
- You keep holding the button for more than 2 seconds after READY disappears.
- The backup battery is critically low and the logger is not connected to power.
Press the CHANNEL button to change the channel on screen. In this example, the display switched from CH1 to CH2.
Note: The sensor cover can be inserted in an unused sensor port.
During Recording
To view more information about clearing alarms and resetting and reviewing trip statistics, please refer to the Product User Guide.
Downloading Results
Connect your UTRED30-16 to your computer via the USB cable provided. The USB socket on the device is located on the bottom, protected by a rubber seal.
A new device drive will appear in file explorer with the files containing the
recorded data for the Channel(s) monitored.
Alternatively, you can follow the steps below:
- Open LogTag Analyzer
- Click
LogTag’ from theDownload’ menu or press `F4′ - Click `Close’ to exit the download page
By default, auto-download is enabled in LogTag Analyzer so when you open the program, data results will be displayed after connecting your UTRED30-16 to your computer
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>