PURELUX DC10-30V LED Extra Light Instructions
- June 6, 2024
- PURELUX
Table of Contents
PURELUX DC10-30V LED Extra Light Instructions
Caution
- Read all the instructions provided before installation.
- Disconnect the ground connection from the battery to avoid accidental short circuits before connecting electrical wires. If mounting requires drilling holes, make sure to avoid damaging any vital components of the vehicle.
- Only operate under the specified voltages (DC10-30V).
- Do not touch the lamp or the casing for at least 30 minutes after turning the light off to avoid heat injury. Keep the heat-sink clean and exposed to maintain air flow.
- Do not stare directly into the light to avoid eye injury.
- Use only soap and water for cleaning. Do not use pressure washer for cleaning.
- Dispose the unit through your local recycling authorities.
Wiring
- Install the mounting bracket to the vehicle and mount the light to the bracket. Secure the fastening.
- Ensure that the working voltage is correct and choose the corresponding relays (DC12V/24V).
- Connect the unit using a Purelux-wiring harness (sold separately).
- Remove any protective films from the lamp before operating.
- Turn on the light to test the connection. If the light is not working as expected, please refer the instructions.
ADDITIONAL INFO
www.valotstore.fi
www.valostore.se
www.valostore.no
HANDSHAKE FINLAND OY
www.handshake.fi
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>