Calix GM1020 GigaMesh User Guide
- June 6, 2024
- Calix
Table of Contents
Calix GM1020 GigaMesh User Guide
1. Connect GigaMesh to power outlet.
2. When the LED is flashing red, you can pair the GigaMesh with the BLAST. Press and hold the WPS buttons on the GigaMesh and then on the BLAST for 3 seconds each (less than 30 seconds apart). The LEDs flash green while attempting to pair.
3. Use the solid green LED indicator (displays for 60 seconds at end of
pairing cycle) to determine ideal location for the GigaMesh. If necessary,
relocate it to a more ideal distance from the BLAST and confirm successful
pairing after the GigaMesh reboots (repeating steps 2-3 as needed).
GigaMesh location is ideal distance from the BLAST.
Note: Once successful pairing is complete, the BLAST and GigaMesh LEDs
will both show a solid cyan (light blue) colour. It may take several minutes
to reach this state.
4. If applicable, use the CommandIQ app to set up the BLAST. See the CommandIQ Quick Start Guide for guidance.
Need help? Contact support: INSERT CONTACT WEBSITE AND/OR TECH SUPPORT PHONE NUMBER
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>