xfinity XiOne 4K WiFi 6 Global Streaming TV Device User Guide
- June 6, 2024
- Xfinity
Table of Contents
Get started
Wireless TV Box
|
Voice Remote 2 AA batteries installed
|
Power adapter
|
HDMI cable
---|---|---|---
- Before you begin, be sure your Wireless Gateway is powered on and activated and within range of your Streaming TV Box.
You can also use an Ethernet cable (not included) to set up a wired connection instead. Please remove the protective clear film from your devices.
If you have a Primary TV Box, be sure that’s also powered on and activated.
2. Secure the HDMI cable between your TV and the Wireless TV Box. Turn on
your TV and select the HDMI Input
3 Plug the power adapter into an electrical outlet and connect the other end
to the Power port on the Box.
Once the power indicator lights up, you’re ready to go. Only use the supplied
power adapter. Avoid outlets controlled by dimmers.
4 Remove the tab from the back of the remote, aim it toward the Box, and wait
for onscreen instructions.
The billing for your new Xfinity service(s) will begin within 5 days from the date your order for service(s) is placed.
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one of the
following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this
equipment.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
This device meets all the other requirements specified in Part 15E, Section
15.407 of the FCC Rules.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20cm between the radiator & your body.
Note: The country code selection is for the non-US models only and is not available to all US models. Per FCC regulation, all WiFi products marketed in the US must be fixed to US operation channels only.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>