hama 00183362 LED10S Power Pack Instruction Manual

hama 00183362 LED10S Power Pack

Controls and Displays

1. On/Off button
2. USB port
3. MicroUSB port
4. USB Type-C port
5. LED capacity indicator
6. 2-in-1cable

Thank you for choosing Hama product.
Take your time and read the following instructions and information completely. Please keep these instructions in a safe place for future reference. If you sell the device, please pass these operating instructions on to the new owner.

Explanation of Warning and Notes

Warning
This symbol is used to indicate safety instructions or to draw your attention to specific hazards and risks.

Note
This symbol is used to indicate additional information or important notes.

Package Contents

• Powerpack with LED capacity display,10000 mAh
• 2-in-1charging cable
• These operating instructions

Safety Notes

• The product is intended for private, non-commercial use only.
• Protect the product from dirt, moisture and overheating, and only use it in an adry environment.
• Keep this product, as all electrical products, out of the reach of children!
•  Do not drop the product and do not expose it to any major shocks.
• Do not operate the product outside the power limits given in the specifications.
• Do not open the device or continue to operate it if it becomes damaged.
• Dispose of packaging material immediately according to locally applicable regulations.
• Since the battery is integrated and cannot be removed, you will need to dispose of the product as a whole. Do this in compliance with the legal requirements.
• Do not modify the product in any way. Doing so voids the warranty.

Operation

Charging the Power Pack

• Begin charging the power pack by connecting the included 2-in-1charging cable to the power pack’sMicro-USB (IN 5V/2A)input and to asuitable USB charger.Alternatively,you can also charge the power pack using the USB Type-C input (IN 5V/3A). Please refer to the operating instructions for the USB charger used.
• Charging begins and ends automatically.
• Charge the Power Pack fully beforeusing it for the first time.

Note –Capacity

• The capacity is always shown when the Power Pack is charging.
• The LED capacity display gives the current charge level as a percentage. The capacity display flashes during charging.
• Ifthe capacity display shows a constant 100%, the power pack is fully charged.
• Press the button of the PowerPack to switch it on and to check its current capacity.
• To switch off the power pack, press and hold the button until the LED display goes out.

Warnung –Battery

• Only use suitable charging devices or USB connections for charging.
• As a rule, do not charge devices or USB connections that are defective, and do not try to repair them yourself.
• Do not overcharge the product or allow the battery to completely discharge.
• Avoid storing, charging, or using batteries in extreme temperatures.
• When stored over a long period of time, batteries should be changed regularly (at least every three months).

Charging terminal devices

• Connect the included 2-in-1charging cable to the power pack’s connection (see 8. Technical Data)and to the Micro-USB or USB Type-C connection of your terminal device (mobile phone, smartphone, etc.).
• The included charging/connection cable may not be suitable for the USB port of your terminal device. In this case, use the USB cable that was included with your terminal device.
• Charging begins automatically. The LED capacity display shows the remaining capacity of the power pack when charging.
• The current battery status of your terminal device will appear on this device.
• Press the button on the power pack and hold it for approximately 2seconds to stop charging and to switch the power pack off. The LED display goes out.
• The Power Pack will automatically switch off if it is not connected to a terminal device.

Warning –Connecting terminal devices

• Before connecting a terminal device, check whether the power output of the charger can supply sufficient power for the device.
• Ensure that the total power consumption of the connected terminal device does not exceed the limit value (see point 8. Technical Data).
• Please refer to the instructions in the operating manual of your terminal device.
• Itisessential that you observe these specifications and the safety instructions regarding the power supply of your devices.
• The power pack must not be charged and discharged at the same time!

Note –Optimised charging

• Optimised charging means that the Power Pack recognizes the connected terminal device and supplies it with the optimal current to minimise charging time.

Warning

• Never connect the charging cable of the PowerPack to both the input and the output of the Power Pack at the same time. This could damage the battery.
• Do not connect any terminal devices while the Power Pack is charging. This could damage the Power Pack and the connected device.

Care and Maintenance

Only clean this product with aslightly damp, lint-free cloth and do not use aggressive cleaning agents.

Warranty Disclaimer

Hama GmbH &CoKGassumes no liability and provides no warranty for damage resulting from improper installation/mounting, improper use of the product or from failuretoobserve the operating instructions and/or safety notes.

Service and Support

Please contact Hama Product Consulting if you have any questions about this product.
Hotline: +49 9091 502-115 (German/English)
Further support information can be found here:
www.hama.com

Technical Data

Recycling Information

Note on environmental protection:

After the implementation of the European Directive 2012/19/EU and 2006/66/EU in the national legal system, the following applies: Electric and electronic devices as well as batteries must not be disposed of with household waste. Consumers are obliged by law to return electrical and electronic devices as well as batteries at the end of their service lives to the public collecting points set up for this purpose or point of sale. Details to this are defined by the national law of the respective country.This symbol on the product, the instruction manual or the package indicates that aproduct is subject to these regulations. By recycling, reusing the materials or other forms of utilising old devices/Batteries, you aremaking an important contribution to protecting our environment.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>