tp-link TL-SG1005D 5/8-Port Gigabit Desktop Switch Installation Guide
- June 6, 2024
- tp-link
Table of Contents
tp-link TL-SG1005D 5/8-Port Gigabit Desktop Switch
LED Explanation
Power
On: Power on
Off: Power off
Link/Act
On: Link present but no activity Flashing: Transmitting/receiving data
Off: No link
Note: For simplicity, we will take TL-SG1005D for example throughout this Guide.
Connection
Frequently Asked Questions (FAQ)
Q1. Why is the Power LED not lit?
The Power LED should be lit when the power system is working normally. If the
Power LED is not lit, please try the following:
A1: Make sure the power cord is connected to the switch with power source
properly.
A2: Make sure the voltage of the power supply meets the requirements of the
input voltage of the switch.
A3: Make sure the power source is ON.
Q2. Why is the Link/Act LED not lit when a device is connected to the corresponding port?
Please try the following:
A1: Make sure that the cable connectors are firmly plugged into the switch and
the device.
A2: Make sure the connected device is turned on and works normally. A3: Try to
change the connected device’s transmission speed and duplex mode.
A4: The cable must be less than 100 meters long (328 feet).
Specifications
General Specifications
Environmental and Physical Specifications
Support
- To ask questions, find answers, and communicate with TP-Link users or engineers, please visit https://community.tp-link.com to join TP-Link Community.
- For technical support and other information, please visit https://www.tp-link.com/support, or simply scan the QR code.
- If you have any suggestions or needs on the product guides, welcome to email techwriter@tp-link.com.cn
EU declaration of conformity
TP-Link hereby declares that the device is in compliance with the essential
requirements and other relevant provisions of directives 2014/30/EU,
2014/35/EU, 2009/125/EC, 2011/65/EU and (EU)2015/863.
The original EU declaration of conformity may be found at https://www.tp-
link.com/en/ce.
Safety Information
- Keep the device away from water, fire, humidity or hot environments.
- Do not attempt to disassemble, repair, or modify the device. If you need service, please contact us. Do not use damaged charger or USB cable to charge the device.
- Do not use any other chargers than those recommended.
- Adapter shall be installed near the equipment and shall be easily accessible.
- Place the device with its bottom surface downward.
- Use only power supplies which are provided by manufacturer and in the origin packing of this product. If you have any questions, please don’t hesitate to contact us.