iRobot Braava Jet 240 Mopping Robot Instructions
- June 6, 2024
- iRobot
Table of Contents
iRobot Braava Jet 240 Mopping Robot
Regular Robot Care
Follow these tips to keep your iRobot Braava jet running at peak performance. See the About your Braava jet® section for reference, as needed.
Cleaning the Cliff Sensors and Pad Reader
Clean the sensors on the bottom of your robot with a damp cloth.
Cleaning the Wheels
Pull off any visible debris or hair that gathers around the wheels.
Cleaning the Body of the Robot
Use a damp cloth to lightly wipe off any dirt on its body or bumper.
Cleaning the Precision Jet Spray Nozzle
Wipe clean with a damp cloth.
*Tested in washing machine. Do not wash with delicates.
Cleaning the Tank
If you notice an odour in the tank, fill the tank with hot tap water. Do not
use boiling water. Close the cap and lightly shake the robot. Rinse the tank
and repeat. Allow the tank to dry with the cap open before using your robot.
Caring for Washable Cleaning Pads
Braava jet Washable pads can be washed up to 50 times* before replacing. Hand
washing and air drying is recommended. If using a washing machine, wash using
the warm cycle and air dry. Do not wash with delicates.
Tips for Best Performance
- For best results, use a Dry Sweeping Pad or vacuum to pick up dirt and dust before running your robot with a Wet Mopping or Damp Sweeping Pad.
- Do not presoak cleaning pads before attaching them to the robot. Pads should be dry at the start of a cleaning cycle.
- To pause your robot during a cleaning cycle, press the CLEAN button. To resume the cleaning cycle, press the CLEAN button again. Do not pick up and move your robot while it is cleaning the robot will end its cleaning run if you do.
- To turn off your Braava jet, press and hold the CLEAN button for 5 seconds.
- Tilt robot slightly when filling to ensure tank fills completely. · Your robot will only run with Braava jet pads, which are specifically made for the robot.
- Braava jet cleans best on smooth hard surfaces and may not perform as well on uneven tiles, heavily waxed floors, or rough surfaces like slate or brick which may snag the cleaning pads.
- Lift up floor-length curtains before running Braava jet.
