TPS800-1 Programmable Tire Pressure Sensor User Manual
- June 6, 2024
- Sensor
Table of Contents
TPS800-1 Programmable Tire Pressure Sensor
TPS800-1 Programmable Tire Pressure Sensor Manual
1. Product Characteristics
TPS800-1 TPS800
The TPS800-1 programmable tire pressure sensor is a tire pressure sensor used
with the TPS800 tire pressure programmer. The tire pressure sensor has the
characteristics of small size and light weight.
TPS800-1 TPS800 95%
The TPS800-1 programmable tire pressure sensor can be used to program the tire
pressure sensor software of various models according to the needs of the
user’s model through the TPS800 tire pressure programmer, so as to support the
use of 95% of the models on the market.
2. Product Parameters
Voltage
Static
Current Send
Protection Class
Main Material
Service life
3.0V 500mA 8mA
IP67 PA66 + GF30
3 Years
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment. NOTE: This equipment
has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures: — Reorient or relocate the receiving antenna. — Increase
the separation between the equipment and receiver. — Connect the equipment
into an outlet on a circuit different
from that to which the receiver is connected. — Consult the dealer or an
experienced radio/TV technician for help. The device has been evaluated to
meet general RF exposure requirement. The device can be u sed in portable
exposure condition without restriction FCC ID: 2A3UN-TPS800-1
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>