Smart Sensor Devices In Sweden Ab SSD 002 Air Quality Monitor Instruction Manual
- June 6, 2024
- Smart Sensor Devices In Sweden Ab
Table of Contents
Smart Sensor Devices In Sweden Ab SSD 002 Air Quality Monitor
How to Connect
FCC
Hibou Air Quality FCC ID: 2AN76-SSD02 Please take attention that changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This device complies with Part 15 of FCC Rules, Opera on is Subject to the
following two conditions:(1) This device may not cause harmful interference,
and (2) This device must accept any interference received including
interference that causes undesired operation. Caution: Any changes or
modificaons to the equipment not expressly approved by the party responsible
for compliance could void the user s authority to operate the equipment. This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a different circuit from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help. For products available on the USA/Canada market, only channels 1 to 11 are available for 2.4GHz WLAN This device and its antenna(s) must not be collocated or operation in conjunction with any other antenna or transmitter except in accordance with FCC’s mul-transfer procedures.
IMPORTANT NOTE: FCC Radiation Exposure Statement; Co-location of this module with another transmitter that operate simultaneously are required to be evaluated using the FCC mul-transfer procedures. This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. The device contains an integral antenna hence, the device must be installed so that a separation distance of at least 20cm from all persons.
Mechanical stress
No mechanical stress shall be applied to any part of the sensor during
assembly or usage. High levels of impact pressure or vibrations may damage the
sensor or generate inaccurate data readings.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>