SENSOR MEDICS Masimo 1863 LNCS DCI Adult Reusable Finger Sensor Instructions
- June 3, 2024
- SENSOR MEDICS
Table of Contents
SENSOR MEDICS Masimo 1863 LNCS DCI Adult Reusable Finger Sensor
Care, cleaning and disinfection of pulse oximeters and patient monitors devices
During monitoring and between patients
Always read and follow the instructions and recommendations of the manufacturer`s manual The device must be cleaned and disinfected after each individual use and, at minimum weekly, prior to use on another patient.
Task/Description
1. Perform risk assessment prior to entry of room| Consider the patient care
tasks that will need to be performed or additional risks that may be
encountered during the disconnection of the device.
---|---
2. Perform hand hygiene|
3. Don appropriate personal protective equipment (PPE)| PPE worn during
disinfectant preparation should include surgical mask/ respirator, goggles or
face shield, long-sleeved fluid resistant gown or gown + apron, rubber gloves,
and boots or closed work shoes.
4. Turn-off and disconnect the device from the patient and power| Turn off
the device and disconnect from the patient and the power and/ or make sure the
batteries are taken out and all patient connections are removed when
clinically safe to do so before cleaning.
5. Move device to a well-ventilated area for cleaning| If monitoring device
is not fixed to patient room/environment, move device away from patients and
other equipment to a designated well-ventilated space where cleaning and
disinfection of the device can be performed.
6. Wipe and clean with detergent (Cleaning)| Wipe the outer surfaces,
sensors, and cables of the device from top to bottom with cloth or disposable
wipe soaked in detergent and clean water and then wipe off any remaining
detergent residue with a dry lint-free cloth.
To avoid permanent damage, do not use excessive amounts of liquids to clean the device.
Use mechanical action (scrubbing) and brushing, if necessary, along the edges and joints to remove visible dirt deposits and calcifications.
7. Prepare disinfectant solutions| Should always be performed before use, in
well-ventilated areas away from patients.
8. Wipe with disinfectant| Prepare a fresh cloth or disposable wipe soaked in
a compatible disinfectant, (e.g. hydrogen peroxide > 0.5%, OR ethanol
70-90%; or as specified by the monitor manufacturer). Wipe the device from top
to bottom, ensuring surfaces of sensors/cables are wiped while avoiding
contact with electrical connectors.
0.1% sodium hypochlorite (1000 ppm) should only be used according to the manufacturer’s instructions if device is known to withstand use of chlorine- based agents and no ammonia-based cleaning agents or acidic body fluids (e.g. urine) are present on the device.
Do not use different disinfectant formulations during the same disinfection step, this may produce toxic fumes.
9. Remove PPE – wash hands| Doff, discard PPE and perform hand hygiene.
10. Store the clean device and disinfect before new use| If device is not
fixed to the patient room/environment, ensure it is stored in an area where
there is low risk of contamination between uses, and that at least 1 minute of
contact time has elapsed after the application of the chosen disinfectant (or
as specified by the manufacturer) before it is used on a new patient.
---|---
Scan me
Documents / Resources
|
SENSOR MEDICS Masimo 1863 LNCS DCI Adult Reusable Finger
Sensor
[pdf] Instructions
Masimo 1863 LNCS DCI, Adult Reusable Finger Sensor, Masimo 1863 LNCS DCI Adult
Reusable Finger Sensor, Reusable Finger Sensor, Finger Sensor, Sensor
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>