TIMER SENSOR TIMER + SENSOR Garden Light Instruction Manual
- June 6, 2024
- TIMER SENSOR
Table of Contents
TIMER + SENSOR
6009011
|
---|---
|
|
INSTALLATION AV TIMER OCH TRANSFORMATOR
- Cable to transformer.
- Cable from the timer to the lights.
- Display
- Photo-cell
- Up/Down Switch Setting
CHECK!
– This is a photo-timer switch that has been designed to be connected to 12
Volt Transformers. This timer can be used for low voltage outdoor
lighting.
-This timer can be installed in and outdoor uncovered. When you install the timer indoors you must take care that the timer can respond to dusk and dawn influences!
– This timer works at a temperature between -20°C and 50°C.
– Maximum Wattage to be connected to the timer is 150 Watt.
CONNECTION OF TIMER AND MAIN CABLE TO THE TRANSFORMER
– Connect the cable with the lights to the photo timer switch
– This timer should be screwed to the wall with the cable to be connected to
the transformer pointing down.
– Connect the input cable of the photo timer switch to the transformer
– Insert the plug of the transformer into the electric outlet
OPERATION PROCEDURES:
0 The timer switch is on, lights always burn.
**A**Auto: From Dusk to Dawn automatically
**1-9**Timer automatically switches on at Dusk. The timer will be switched
on during the the time mentioned on the display (1-9)
With certain installation, the lights should work now. If not, check the
following things:
– Connections between the main cable and the wire from the lamp.
– Check the lamps.
– When no single light is working, check the transformer and/or timer and let
a specialist measure them both.
FUSE
This timer is secured against short-circuiting. – (250V – 20A)
For questions about parts, service, any complaints, or other matters, you can
contact us at any time. E-mail: [email protected]
MI3885 – 20171221
Documents / Resources
|
TIMER SENSOR TIMER + SENSOR Garden
Light
[pdf] Instruction Manual
Garden Light, LGL00062, TIMER SENSOR, AV, Timer, OCH, Transformator, 6009011
---|---