Onyx BOOX Note Air 2 with Free Case and Stylus User Guide
- June 6, 2024
- ONYX
Table of Contents
| 
---|---
1. Power 2.USB-C Port 3. Mic
a. BOOX Device
b. Warranty Card
c. Quick Start Guide
d. Stylus Pen
e. USB-C Cable
f. Protective Film
QUICK START GUIDE
Turn on the device: Hold down the power button for 2-3 seconds.
Charging: When the pottery is low or the device can not be turned on,
please connect your BOOX with a PC or an Adaptor to charge it. When the device
is charging, the indicator shows red. When the battery is fully charged, the
indicator turns blue.
Firmware update: Download the update packages to the root directory of
the local storage, or get OTA updates on the device. To force shutdown, please
hold the power button for about 15 seconds You can read the full version of
the User Manual on the official BOOX website:
https://www.boox.com/downloads/
FCC Statement
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
–Reorient or relocate the receiving antenna.
–Increase the separation between the equipment and receiver.
–Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
–Consult the dealer or an experienced radio/TV technician for help. Changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Radiation Exposure Statement
This device complies with RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>