OTTER PRODUCTS OBFTC-0087-A Power Bank User Guide
- June 6, 2024
- OTTER PRODUCTS
Table of Contents
OTTER PRODUCTS
POWER BANK
QUICK START GUIDE
OBFTC 0087 A
FULLY CHARGE FOR FIRST USE
While charging display continually shows (Fig. 1):
-
1 flashing LED < 25% capacity
-
1 solid LED, 1 flashing LED 25-50% capacity
-
2 solid LEDs, 1 flashing LED 50-75% capacity
-
3 solid LEDs, 1 flashing LED 75-99% capacity
-
4 solid LEDs 100% capacity
When not charging, press the button to view capacity (Fig. 2): -
No LEDs 0% capacity
WIRELESSLY CHARGE DEVICES (IF APPLICABLE)
Press the button and place your device flat on the side of the Power bank
featuring the OtterBox logo.
Orange light blinks while detecting your device and stops blinking if the
device is not detected.
The orange light blinks when a device is connected and charging.
CARE & MAINTENANCE
Cleaning
- Wipe with a dry cloth.
- Do not use solvents, chemicals, cleaning solutions, alcohol, ammonia, or abrasives.
MANUFACTURER
Otter Products LLC
209 South Meldrum Street, 80521, Fort Collins, Colorado, United States of
America
IMPORTER
Otter Products EMEA
5th Floor Hibernian House,80A South Mall, Cork, Ireland.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
- 1 flashing LED 0-10% capacity
- 1 solid LED 10-25% capacity
- 2 solid LEDs 25-50% capacity
- 3 solid LEDs 50-75% capacity
- 4 solid LEDs 75-100% capacity
CHARGE devises
The power bank automatically starts charging most devices.
CUSTOMER SERVICE
1 855 688 7269
USA + Canada – Toll-Free support@otterbox.com
otterbox.com/support
COMPLETE USER MANUAL MODE D’EMPLOI COMPLET OTTERBOX.COM/SAFETY-
INSTRUCTIONS
DE Gesamtes Benutzerhandbuch IT Manuale Utente Completo ES Manual de Usuario
Completo PT Manual do Utilizador Completo
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY
TO PERSONS
IMPORTANT SAFETY INSTRUCTIONS
WARNING – When using this product, basic precautions should always be
followed, including the following:
a) Read all the instructions before using the product.
b) To reduce the risk of injury, close supervision is necessary when the
product is used near children.
c) Do not put fingers or hands into the product.
d) Do not expose the power bank to rain or snow.
e) Use of a power supply or charger not recommended or sold by power pack
manufacturer may result in a risk of fire or injury to persons.
f) Do not use the power bank in excess of its output rating. Overload outputs
above rating may result in a risk of fire or injury to persons.
g) Do not use the power bank that is damaged or modified. Damaged or modified
batteries may exhibit unpredictable behavior resulting in fire, explosion, or
risk of injury.
h) Do not disassemble the power bank. Take it to a qualified service person
when service or repair is required. Incorrect reassembly may result in a risk
of fire or injury to persons.
i) Do not expose a power pack to fire or excessive temperature. Exposure to
fire or temperature above 100°C may cause an explosion. The temperature of
100°C can be replaced by the temperature of 212°F.
j) Have servicing performed by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the product is
maintained.
k) Switch off the power bank when not in use.
changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
ISED compliance statement
This device contains license-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science, and Economic
Development Canada’s license-exempt RSS(s). Operation is subject to the
following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
Radiation Exposure statement
This equipment complies with FCC/IC RSS-102 radiation exposure limits set
forth for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 20
cm between the radiator and your body.
Project Name: INSERT CARD POWER BANK QUICK START GUIDE
Designer: Rowell
Part #: 20-55265
Rev: A
Date: 4.28.2020
Dieline and material shall follow: 23-84697
Colors Coatings and Treatments:
Process Black
PMS 109
NOT FOR PRINT –
FOR REFERENCE ONLY
Dielines- do not print
Folds- do not print
Notes:
Accordion Fold
Confidential property of Otter Products LLC
Reproduction and unauthorized use is prohibited
Otterproducts LLC:
209 South Meldrum Street,
Fort Collins, CO 80521
OTTER PRODUCTS
Documents / Resources
|
OTTER PRODUCTS OBFTC-0087-A Power
Bank
[pdf] User Guide
OBFTC0087A, 2AEEV-OBFTC0087A, 2AEEVOBFTC0087A, OBFTC-0087-A Power Bank, Power
Bank, Bank
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>