ATRIX HKWP1220-10Q 10W Wireless Charger User Guide

ATRIX HKWP1220-10Q 10W Wireless Charger User Guide

• Material: 105gsm double side art paper( C2S).
• Color: Black
• Surface coating: glossy varnish.

Need Help?

Have any questions or comments? Need help getting set up? Contact us at https://care.gamestop.com

What’s Included

• Wireless Charger
• Wall Charger
• USB-A to Micro-USB Charging Cable (charging cable does not transfer data)

Charging Indicator

• Flashes Blue , Green, and then both – Power on
• Solid Blue – Charging your device
• Solid Green – Fully charged
• Flashing Blue – Foreign object detection, pieces of metal or other materials may cause overheating and damage your charger or phone. Remove them immediately.

Charging

• Place the charger on a sturdy flat surface.
• Using the Micro-USB cable provided, plug the cable into the wall charger or a USB power supply of DC 5V 2A minimum warning: please use ETL compliant power supply .
• Place your Ql-enabled device onto the wireless charger and align the device with the center of the charging surface or the device will not charge.
• Remove credit cards or any card with a magnetic strip to prevent damage to the cards before charging,
• Charge time will vary by device.

Troubleshooting

• Double check that the Micro-USB cable is plugged in and the DC 5V 2A power source is working.
• Certain phone cases may interfere with wireless charging.
• Remove the phone case for best results.
• Double check the placement of the device on the wireless charger. For best results, the center of the device should be on the center of wireless charger.

FCC ID: 2AOZl-OSOCo0’1 Model: HKWP1220-10Q
Input: 5V-2A 9V-1.67A Output: 10W Max

Important Safety Instructions

WARNING When using this product, basic precautions should always be followed, including the following:

• Read these instructions carefully.
• All cautions and warnings should be followed.
• Protect equipment from humidity.
• Do not use chemical detergents to clean your device, use a soft dry cloth.
• To avoid damage from electrical peaks unplug the device when it is not in use.

If one of the following situations arise, equipment has to be checked by qualified service personnel:

• Liquid has penetrated into the equipment.
• Equipment has been exposed to humidity
• Equipment has been dropped and/or is damaged.
• Equipment has obvious sign of breakage.
• Equipment does not work well or you cannot get it working according to user’s manual.

SAVE THESE INSTRUCTIONS

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:

1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation

WARNING Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Made in Vietnam

ATRIX

Geeknet, Inc. 625 Westport Pkwy, Grapevine, TX 76051

Phone: 855-474-7717

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>