ATRIX Wireless Gaming Mouse with RGB User Guide
- June 5, 2024
- ATRIX
Table of Contents
wireless Mouse user guide
WIRELESS MOUSE INSTRUCTIONS
Material: 105gsm double side art paper( C2S).
Color: Black + Pantone cool gray 8c
Surface coating: glossy varnish.
Need Help?
Have any questions or comments? Need help getting set up? Contact us at
https://care.gamestop.com
What’s Included
- USB-C Wired and 2.4G Wireless Dual Mode Gaming Mouse
- USB-C to USB-A charging cable
- USB-C to USB-A adapter (Giveaway)
- 2.4Ghz Dongle (Bottom of the mouse)
Adjusting DPI
- Press the DPI button to adjust the DPI. When the DPI is switched the LED will change color.
800 DPI (Red) > 1600 DPI (Blue) > 3200 DPI (Green) > 4800 DPI (Yellow) > 6400 DPI (Cyan) > 16000 DPI (Purple)
LED Indicators
- Flashing Yellow Light – Charging
- Flashing Red Light – Low Battery
Charging the Mouse
- Plug the USB-C end of the charging cable into the mouse.
- Plug the USB-A end of the charging cable into your computer.
- A full charge requires approximately 2.5 hours.
- The light will flash yellow when it is charging and then return to the color indicated by DPI after charging is complete. Note: The mouse still works when it is charging.
Wired and Wireless Function
- Wired and wireless mode switch automatically. When you insert the 2.4Ghz dongle into your computer without a cable connection, it will work in wireless mode.
- When you connect the cable from the computer to the mouse, it will switch to wired mode automatically and work as wired mode.
FCC ID for Dongle: 2A023-ME4 Model: ME4 Made in China
FCC ID for Mouse: 2A023-GSME04 Model: GSME04 Input: DC5V= 500mA
Important Safety Instructions
WARNING When using this product, basic precautions should always be
followed, including the following: Read these instructions carefully.
All cautions and warnings should be followed.
Protect equipment from humidity. Do not use chemical detergents to clean your
device, use a soft dry cloth. To avoid damage from electrical peaks unplug the
device when it is not in use. one of the following situations arise, the
equipment has to be checked by qualified service personnel:
- Liquid has penetrated into the equipment.
- Equipment has been exposed to humidity.
- Equipment has been dropped and/or is damaged.
- Equipment has obvious signs of breakage.
- Equipment does not work well or you cannot get it working according to the user’s manual.
SAVE THESE INSTRUCTIONS
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation. Warning: Changes or
modifications to this unit not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
nterference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help. Shielded cables must be used with this unit to ensure compliance with the Class B FCC limits.
ATRIX. Geeknet, Inc. 625 Westport Pkwy, Grapevine, TX 76051 Phone: 855-474.7717