ATRIX GSHP59 Wireless headphone User Manual
- June 6, 2024
- ATRIX
Table of Contents
GSHP59 Wireless headphone
User Manual
Need Help?
Have any questions or comments? Need help getting set up?
Contact us at https://care.gamestop.com
What’s Included
- Wireless Headphone
- 3.5mm Aux Cable
- USB-A to Micro-USB Charging Cable (Note: charging cable does not transfer data)
Headphone LED Indicators
- Rapid Flashing Red and Blue – Pairing
- Flashing Blue-Paired
- Flashing Red – Low Battery
- Solid Red – Charging
- No Red light – Charging complete
Pairing the Headphones
-
Pairing:
-
Power ON the When pairing for the first time the headphones will automatically enter pairing mode. The Indicator Light will flash red & blue on the right side of the headphones.
-
Use the Bluetooth settings on your device to pair with When the indicator lights flash blue every 5 seconds the pairing was successful.
Note: Hold the power button for 3 seconds to power on/off. -
Re-enter Pairing:
-
To re-enter pairing mode disconnect from your device using the Bluetooth
-
To re-enter pairing hold the volume up and down buttons for 3 seconds to disconnect, the light will flash blue Use your device to connect using the pairing instructions.
Charging the Headphones
- Plug the Micro-USB end of the charging cable into the headphone.
- Plug the USB-A end of the charging cable into a UL-compliant power supply of at least DC 5V 500mA.
- A full charge requires approximately 3 hours.
- The red light will turn blue when charging is complete.
Noted: headphones can not play back when charging.
AUX Setup
- The headphone comes with an AUX cable
- Plug the AUX cable into the headphones and into your device.
EQ Mode
- Press the EQ Mode button once to turn on EQ mode and enhance the bass effect.
Note: All button functions and LED Indicator are for buletooth only
Important Safety Instructions
WARNING When using this product, basic precautions should always be followed,
including the following:
Read these instructions carefully.
All cautions and warnings should be followed.
Protect equipment from humidity.
Do not use chemical detergents to clean your device, use a soft dry cloth.
To avoid damage from electrical peaks unplug the device when it is not in use.
If one of the following situations arise, the equipment has to be checked by
qualified service personnel:
- Liquid has penetrated into the equipment.
- Equipment has been exposed to humidity.
- Equipment has been dropped and/or is damaged.
- Equipment has obvious signs of breakage.
- Equipment does not work well or you cannot get it working according to the user’s manual.
SAVE THESE INSTRUCTIONS
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
Headphone FCC ID: 2A023-GSHP59
Model: GSHP59
Input: DC5V 500mA
Made in China
Geeknet, Inc. 625 Westport Pkwy, Grapevine, TX 76051 Phone:
855-474-7717
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>